Post Your Technical Information Requests

[Mr. GP1800]

Hi. I'm looking for links on large scale gelcoat repair on the bottom of the hull. THanks.
Also, sslongmuir, i have the polaris 1992-1998 service manual. If you havent seen it, message me if you need it

Its not gel its paint

[kaotic1]

can anyone give me a part # or direct me to where i can get the 4 special o-rings inside the ficht injectors

[GoodWComputers]

Does a document exist that lists all the part numbers for my '97 SLT700? So far I've been using this site: http://parts.polarisind.com/Browse/Browse.asp

Props to beerdart for providing it here: http://www.greenhulk.net/forums/showthread.php?t=25977

I'd love it if there was a .pdf that I could print and take with me into my workshop to use as a quick reference guide for looking up part numbers. Keywords: something I can print.

Does this exist?

[71chevelle]

hi i have 96 polaris sl900 runs but wont shut off when i push kill switch or when i remove lanyard any ideas would be appreciated

[casey67]

hi i have 96 polaris sl900 runs but wont shut off when i push kill switch or when i remove lanyard any ideas would be appreciated

Welcome to Green Hulk.

I had a 1050 do that.
Litterally, the black/ with yellow stripe wire from the CDI is grounded to shut off the engine.
You need to check that wire in the electrical box to see if you get a good ground signal.
You need to check

[mikie95]

Hi Guys,

I am dealing with a real stiff throttle cable on my Polaris SL1050. What do you guys recommend to use to lubricate the cable? Polaris manual recommends "Polaris Cable Lube". Anyone out there have an idea on what the equivalent off the shelf lubricant would work?

[NCJ0N]

anyone know a work around for DW?
A working registration number / method would be greatly appreciated!

[K447]

anyone know a work around for DW?
A working registration number / method would be greatly appreciated!

There is a previous posting showing a valid number

[JohnScott]

I am currently going through newly acquired 95 650 sl and have found the Clymer shop manual helpful with specs./ torques.