Results 1 to 3 of 3
Thread: 2011 RXPX 20 Hours
-
04-23-2013, 04:21 PM #1
- Join Date
- Jun 2007
- Location
- My House
- Posts
- 4,108
- +1
- 335
2011 RXPX 20 Hours
2011 RXPX 20 hours on complete boat:
2007 RXP 4-Tec Engine w/New Rods, New Riva 9.5's w/rings, Bearings, Bolts, Crank Emmaculate, w/160 Thermo, Block Gaurd, NEW rebuild 0 hours
Stock ECU, Injectors, Charger
Speedfreeks Lightened 29 Cam
Ported Head
Ported Exhaust Manifold
Modded Intercooler Location
Modded Water Box
Polished LH Rear Outlet Exhaust Tip
Engine Catch Can
4" Kanoflex Air Intake
Air Intake Restrictor Removed
RE Block Offs
Speedfreek Rideplate
Speedfreek Lightened Driveshaft
Speedfreek Drive Shaft Bellow Band
R&D Intake Grate
Walbro Fuel Pump
Fuel Pressure Regulator w/Gauge
Riva Prop & Speedfreek Noze Cone
Pump Relief System
Stainless Wear Ring
Stainless Tubing Front Hood Bling
Water Strainer
02 Sensor Exhaust port
(2) Bilge Pumps
Cosmetic Issues
1) Unit was bought new after dealer rolled it on its top off a crate accidentally new.......gell coat stress cracks only and i had them fixed and painted over and as inexpensively as possible........they can still be seen but do not hinder anything other than looks if u look closely.
2) Seat has been run over and is broke and torn.........seat still works fine just looks bad with small tears and a cracked bottom
3) Chrome Boomerang on hood has chip from roll over.
4) Footwell pads have some scratches and dings in them.
Cosmetically the boat is a 6/7
Mechanically 10
If the boat had a new/used seat and you wanted to do some gelcoat work just to not see the stress cracks under the paint it would be a 11k boat easily......or it can be ridden and run just as it sits and i have for 20 hours and has not lost any gelcoat as the cracks are on top and will hinder nothing
...boat can be ridden on the TEST TRACK behind my house upon pickup
......
PM,text for inquiries @ 317-697-5957 or email @ reid2168@sbcglobal.net........$7900.00
Thanks in advance for looking...........BINESS!!!!!!!
Last edited by REID2168; 04-24-2013 at 08:12 PM.
-
04-24-2013, 08:13 PM #2
- Join Date
- Jun 2007
- Location
- My House
- Posts
- 4,108
- +1
- 335
Sale Pending
.......thx for looking!!!!!!!!!!!!!
-
05-09-2013, 11:16 AM #3
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
RXPX First Service 20 hours?
By Lstorm2003 in forum 4-Tec PerformanceReplies: 4Last Post: 10-14-2015, 01:23 PM -
Which one to haul 20 hours?
By pe4me in forum 2-Stroke PerformanceReplies: 2Last Post: 05-25-2008, 12:48 PM -
07 rxp 20 hours cavatates but runs 70mph
By chokehold in forum 4-Tec PerformanceReplies: 8Last Post: 08-12-2007, 02:50 PM -
20 Hour Service?
By evopro1 in forum Sea Doo Open DiscussionReplies: 2Last Post: 07-31-2006, 10:34 AM -
Skat Trak dual bearing/ss wear ring 20 hour inspection
By Mark S in forum 4-Tec PerformanceReplies: 3Last Post: 08-16-2005, 11:25 AM
Never did pull the trigger on that Ocean Pro plate, figured I'd like to...
785 project - restoration work