Results 1 to 2 of 2

Thread: intake grate

  1. #1

    intake grate

    Has anyone ever tried sanding or filing the front part of an 800 grate where it bolts to the hull? I think it would raise the scoop of the grate a little causing less drag for top speed runs but how much is too much when doing this causing not enough water into the pump tunnel area??? I'm sure someone has had to try this at some point...right?

  2. #2
    txgp1300r's Avatar
    Join Date
    Apr 2006
    Dallas , Texas
    I put mine in the mill and trimmed it front and back just to square it up...i guess you could angle mill the front and back to decrease the angle, but you will also lessen your hook up....800 grates bounce your azz all over the lake if there is chop...but are a little faster top end.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. found out what my rxp is running with the intake grate
    By kenshin89 in forum 4-Tec Performance
    Replies: 11
    Last Post: 03-17-2007, 02:09 PM
  2. Intake grate advice needed
    By Jeff C in forum 4-Tec Performance
    Replies: 10
    Last Post: 08-15-2005, 01:32 AM
  3. Trueing rideplate and intake grate
    By 01xdime in forum 4-Tec Performance
    Replies: 8
    Last Post: 08-12-2005, 09:10 AM
  4. intake grate ?
    By Krazy-K in forum 4-Tec Performance
    Replies: 1
    Last Post: 07-12-2005, 09:43 PM
  5. Intake grates
    By SUPERBEAST in forum 4-Tec Performance
    Replies: 14
    Last Post: 06-05-2005, 12:57 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts