Results 1 to 2 of 2
  1. #1
    xray328's Avatar
    Join Date
    Aug 2011
    Shorewood, IL

    Can the powervalves be removed without destroying the wave eater clips?

    GPR is running 58mph on pretty smooth water with a d-plate and free flow exhaust and stepped sponsons on the buzzer. I think something's up with the power valves. I'm going to make sure they are adjusted properly first, but when I installed the clips the valves looked pretty gross from Yama sludge being run in it. So if they are aligned, cleaning them will be the next step.

    Can the valves be taken out without destroying the clips? Should I just try to clean what I can with the valves in place?


  2. #2
    Happily Self-Employed WFO's Avatar
    Join Date
    Nov 2005
    Houston, Texas
    I always like to remove the valves when cleaning them... that way all the crap doesnt fall down into the cylinder.

    you can gently pry the sides of the clips, then the top and it should pop right off

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Replies: 4
    Last Post: 03-14-2016, 07:22 PM
  2. Can #2 cylinder be removed with manifold in place?
    By steach in forum Yamaha PWC Performance (2-stroke)
    Replies: 10
    Last Post: 02-11-2012, 08:42 PM
  3. can the "planet exhaust" be removed?
    By johnhoskins93 in forum Polaris How To & FAQs
    Replies: 0
    Last Post: 08-03-2011, 07:09 PM
  4. Can I re-use the PV gaskets when putting in Wave eater clips?
    By DarkCanuck in forum Yamaha PWC Performance (2-stroke)
    Replies: 3
    Last Post: 06-30-2011, 03:36 AM
  5. can the ultra pump be removed w/o taking off the rideplate?
    By 1FastRXP in forum Kawasaki PWC Performance (4-stroke)
    Replies: 6
    Last Post: 04-29-2007, 08:45 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts