Results 1 to 3 of 3

Thread: sand

  1. #1

    Question sand

    need some help dont know if this is right place to put this,
    just got an old sx550 1990 pre reed valve,
    just been and water tested it and the cooling pipe from the pump to the engine is full of wet hard sand, ive taken the exhaust manifold off and its not made it to the engine just wanted to know how im going to remove this sand? thanks in advance for any help..justin..

  2. #2
    steve45's Avatar
    Join Date
    Feb 2008
    I'd get a piece of drive cable from an old speedometer/tachometer and poke it through. You might chuck the cable in a drill.

  3. #3
    Thanks steve just got around to sorting this and it worked cheers fella big help.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. polish or sand ?
    By BR549 in forum Yamaha PWC Performance (2-stroke)
    Replies: 5
    Last Post: 05-14-2007, 11:22 PM
  2. Sanding for Hydroturf?
    By Chrisrokc in forum Yamaha PWC Performance (2-stroke)
    Replies: 14
    Last Post: 03-01-2007, 01:35 AM
  3. sanded hull bottom. Mythe or no?
    By xlint89 in forum Polaris Open Discussion
    Replies: 16
    Last Post: 12-26-2006, 04:19 PM
  4. Should I sand these smooth???
    By WildBill9000 in forum 4-Tec Performance
    Replies: 4
    Last Post: 11-25-2005, 10:30 PM
  5. Sand/Mud in the impeller
    By Gforce in forum 4-Tec Performance
    Replies: 8
    Last Post: 06-06-2005, 12:14 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts