Results 1 to 3 of 3
  1. #1

    Can this crank case be reused?

    I was tearing down my motor last night and there was some unexpected pitting at the bottom of the crank case. No holes in the case, but I was surprised about the pitting as it wasn't on the cylinder that went out. I'll grab some pictures this evening, but was curious if this would be an concern and if it can be fixed, or is it worth fixing.

    Really the crank, #1 piston, and #1 cylinder are bad so it isn't getting fixed, but didn't know if the case had value in it's current state.

  2. #2

    Join Date
    Mar 2012
    Just where it spun the dial pins on the crank it'll be fine for use still.

  3. #3
    Thanks, I haven't gotten around to getting a picture yet. I thought it'd be fine for use, but wasn't 100%

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. 07 215 4-tec Crank case bolts reuse?
    By synergy141 in forum 4-Tec Performance
    Replies: 2
    Last Post: 04-13-2015, 08:21 AM
  2. Can this gasket be reused a few times?
    By jetdave56 in forum Yamaha PWC Performance (2-stroke)
    Replies: 6
    Last Post: 12-18-2010, 02:30 PM
  3. Can this be fixed? Impellor takes on Rock....Rock wins
    By havoc in forum Yamaha PWC Performance (2-stroke)
    Replies: 13
    Last Post: 06-04-2007, 06:24 AM
  4. Can this bearing be re-used??????
    By lawracing in forum 4-Tec Performance
    Replies: 12
    Last Post: 06-13-2006, 02:10 AM
  5. How can this be...?
    By rx4pain in forum 4-Tec Performance
    Replies: 9
    Last Post: 06-10-2005, 06:04 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts