Results 1 to 5 of 5
-
01-07-2012, 08:58 AM #1
- Join Date
- Oct 2011
- Location
- Ontario Canada
- Posts
- 203
- +1
- 4
96 slt 780 oil line to the drive shaft area
i could use a diagram of the oil lines and what started this thread was to understand the oil line that goes to the drive shaft area just below the grease nipple - i suspect its for the drive line lube ?
-
01-07-2012, 11:04 AM #2
i "think" you are taking about the speedometer tube. this comes from a nipple/pick up under the drive shaft, and goes to your MFD. it is a clear, 1/8 inch line.
the only oil lines you have are one feed line from the tank, to the oil pump, then the 3 lines from the pump to the motor.
-
01-07-2012, 12:53 PM #3
- Join Date
- Oct 2011
- Location
- Ontario Canada
- Posts
- 203
- +1
- 4
excellent - i wondered why it looked like it had no oil in it , thanks - that makes sense - thanks again for the carb kits and solid advice !
-
01-07-2012, 07:39 PM #4
There is also a clear tube floating around down there that connects to the battery vent if you are using a conventional battery.
-
01-16-2012, 06:16 AM #5
- Join Date
- Oct 2011
- Location
- Ontario Canada
- Posts
- 203
- +1
- 4
thanks - yes i thought the speedo tube had been replaced and now it makes sense . thanks
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Engine Swap 95 SLT 750 to a 96 SLT 780
By jason2821 in forum Polaris Open DiscussionReplies: 10Last Post: 06-04-2013, 08:01 AM -
grease nipple on the drive shaft of 780 - 96
By ktheake in forum Polaris Open DiscussionReplies: 15Last Post: 01-24-2012, 08:35 AM -
Polaris oil tank, cap, valve from 96 SLT 780
By tg2861 in forum Polaris ClassifiedsReplies: 0Last Post: 07-20-2008, 12:51 AM -
Fuel line restrictor on 96 SLT 780....
By Rodneyae in forum Polaris Open DiscussionReplies: 18Last Post: 04-14-2008, 10:07 AM -
96 SLT 780 questions
By BBCaprice in forum Polaris Open DiscussionReplies: 13Last Post: 05-14-2007, 10:25 AM
Never mind guys; just read the post titled Lucky 13 cone on my GP 1800...
85mm nozzle and Lucky 13 pump cone