Results 1 to 9 of 9
Thread: Pump support question
-
12-21-2011, 06:59 PM #1
Pump support question
Doing major overhaul of bottom end of ski this winter and noticed on the support, where the pump actually seals, is somewhat out of round and the mating surface is anything but flat. I can't imagine it creating a good seal to the pump. Has anyone noticed this on others? Put a new seal on pump only a few hours ago and it already has spots where it is deformed from not seating properly.
-
12-21-2011, 07:54 PM #2
-
12-21-2011, 08:05 PM #3
Don't think you could see in pic. I can run my finger around the sealing surface and it is very lumpy. I could try and smooth it out with dremel, just wondering if this is typical and if I should even bother.
-
12-21-2011, 08:11 PM #4
The seals are pretty forgiving, it would be hard pressed for me to believe the support could be that far out of whack..
-
12-21-2011, 08:26 PM #5
Thanks for the input. Just trying to cover all the bases, have some speed issues and I think some are due to cavitation.
-
12-21-2011, 08:49 PM #6
-
12-21-2011, 09:23 PM #7
Going through with a fine toothed comb right now. This was just the first stop
-
12-21-2011, 09:29 PM #8
Never really acted like cavitation but had some pitting on the trailing edge of prop. Was leaning more towards shoe and engine alignment, Going bigger everything this winter and want to make sure everything is good as I go.
-
12-22-2011, 10:05 AM #9
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
RXTX 2010 pump and pump support Question
By Sylvius in forum 4-Tec PerformanceReplies: 4Last Post: 12-23-2014, 08:54 AM -
Sucked up rocks :( Pump support teeth question?
By cfnnslsq in forum Sea Doo Sport BoatsReplies: 1Last Post: 09-02-2007, 05:54 PM -
Question on Damage to Pump Support
By meeper in forum 4-Tec PerformanceReplies: 17Last Post: 09-11-2006, 02:51 PM -
pump support question
By Tiplickhahaha in forum Sea Doo Open DiscussionReplies: 2Last Post: 06-02-2006, 02:52 PM -
(Damaged) Pump Support Question
By Snoman in forum 4-Tec PerformanceReplies: 6Last Post: 04-13-2006, 06:37 AM
I was looking at antons way under the manifold which dosent go through any...
Ultra 310 AFR