Results 1 to 10 of 22
Thread: Running bad
-
09-28-2005, 05:07 PM #1
- Join Date
- May 2005
- Location
- biggs ca.
- Posts
- 166
Running bad
Have not been out for three or four weeks and went out today and warmed it up hit the throttle took off and then fell on its face, It was running rough and would hardly go at all. Any ideas could it be battery charge, It shows no codes.
Thanks
-
09-28-2005, 05:38 PM #2
Can you feather it up to speed?
Does it just happen when you pin it?
Does it die when you pin it?
Give us more details of exactly what is happening.........
-
09-28-2005, 06:04 PM #3
- Join Date
- May 2005
- Location
- biggs ca.
- Posts
- 166
You can't feather it up. Sounds like it is missing real bad.
-
09-28-2005, 06:33 PM #4
- Join Date
- May 2005
- Location
- biggs ca.
- Posts
- 166
I forgot to say it was an RXP
-
09-28-2005, 07:47 PM #5
Well, check the following:
Gas, is it ok, water in it?
Oil, proper level, look ok
Spark Plugs, fouled (sounds like whats wrong)
Supercharger is probably ok, cause they won't make i run bad, just no power.
Layard, not the learning key?
Press SET 5 times see if you get a code or just END
check pump, something stuck in impeller or on drive shaft.
places to start anyway..
-
09-28-2005, 09:32 PM #6
- Join Date
- May 2005
- Location
- biggs ca.
- Posts
- 166
Did all that and looks good
-
09-28-2005, 10:09 PM #7
Does it still have rpm issues on the trailer back home? How low are the rpm's stuck at?
-
09-28-2005, 10:15 PM #8
- Join Date
- May 2005
- Location
- biggs ca.
- Posts
- 166
Yes it does it on the trailer, And it won't go hardly at all. I am a mechanic and it acts about like plug wires are crossed.
-
09-28-2005, 10:17 PM #9
and no trouble codes at all?
Are you getting "End" after you press set 5 times?
-
09-28-2005, 10:53 PM #10
sounds like you could have water in the intake.. is it ok just above idle, then sucks up water under acceleration??? mine did that after stabbing into a wave coming back in the inlet 1 time. Also do you have the RR I/C , and plumbing? sometimes when I pull my I/C plumbing tubes I see water come out of the lower pipe.(condensation I guess?)
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Starts fine but runs bad
By Piney in forum Sea Doo Open DiscussionReplies: 0Last Post: 05-03-2008, 03:53 PM -
'02 Virage i - Runs Bad When Cold
By sprint27c in forum Polaris How To & FAQsReplies: 10Last Post: 07-01-2007, 04:27 PM -
95 xp running bad
By pappastratos in forum 2-Stroke PerformanceReplies: 5Last Post: 05-22-2007, 02:54 PM -
gp800 poor running , bad miss fire
By w-nut in forum Yamaha PWC Performance (2-stroke)Replies: 0Last Post: 02-12-2007, 10:37 PM -
Still running bad - tried everything!
By Phil in forum 4-Tec PerformanceReplies: 29Last Post: 10-04-2005, 11:22 PM
Hey guys i picked up a SL900 that ran in the driveway , stuffed it in...
SL900 with update , wont fire up.