MAINT Light help!

[BigBoyRXP]

So I'm trying to get ski ready for summer! I've noticed that every time you turn the SKI on it says MAINT and it only does ONE long beep! After maint disappears it has 4 short beeps which from what I read are normal meaning system ready. I've tried holding SET for 2 seconds to reset MAINT code but it keeps popping up when I take key out and back on. Its been doing this since I bought it in August, I took it out a few times before winter came and it ran fine.

[RXP rider]

Your dealer need to reset the maint in BUDS

[Snoman]

Your dealer need to reset the maint in BUDS

+1...Have you had the Scer washers replaced in that thing yet???

[BigBoyRXP]

Yes charger washer have been changed. I don't have a dealer around me. Is there a way to see a problem code or something?

[beerdart]

Yes charger washer have been changed. I don't have a dealer around me. Is there a way to see a problem code or something?

No codes or faults the maint message gets displayed @ 75 or 100 hours? You can just ignore it and nothing will happen and performance will not suffer.

[alex_baker202]

So I'm trying to get ski ready for summer! I've noticed that every time you turn the SKI on it says MAINT and it only does ONE long beep! After maint disappears it has 4 short beeps which from what I read are normal meaning system ready. I've tried holding SET for 2 seconds to reset MAINT code but it keeps popping up when I take key out and back on. Its been doing this since I bought it in August, I took it out a few times before winter came and it ran fine.

This happened to me when my exhaust sensor was unplugged

[BigBoyRXP]

Well thats what I thougt about the hours but your suppose to be able to reset it. I have a dude wanting to buy it Thursday and I'm scared to keep it if it's something big.

[beerdart]

It can only be reset by BUDS or Candoo.

[dnielsen]

So I'm trying to get ski ready for summer! I've noticed that every time you turn the SKI on it says MAINT and it only does ONE long beep! After maint disappears it has 4 short beeps which from what I read are normal meaning system ready. I've tried holding SET for 2 seconds to reset MAINT code but it keeps popping up when I take key out and back on. Its been doing this since I bought it in August, I took it out a few times before winter came and it ran fine.

You can buy the new CanDoo system and reset it yourself of simply take it to Campers RV out near Water Town in Greenwood (thats only 15 - 20 minutes from Bossier). They are the BRP Seadoo dealer. I'm sure they can figure out how to use the BUDS system even if you have to ask questions on the forum for them. I havn't had much luck with them in the past or more complex issues but surely they can reset it.

[BigBoyRXP]

Whats the procedure to read P-Codes?