Results 1 to 4 of 4
Thread: impeller possible problem
-
02-23-2011, 04:18 AM #1
- Join Date
- Nov 2008
- Location
- greece,Europe
- Posts
- 95
- +1
- 8
impeller possible problem
hello this is a question to jerry and everyone
if we repitch an impeller by bendin with a wrench all blades is there possible to damage the pump bearrings and the drivesaft when you reinstall the impeller at pump y not spin correctly(spinning unbalanced)?how could be so sure tha the bending dont differe eatch over even its only .01mm .at 7500 and 8000 rpms this will effect the ballance of whole drive saft
-
02-23-2011, 04:19 AM #2
- Join Date
- Nov 2008
- Location
- greece,Europe
- Posts
- 95
- +1
- 8
sorry for the writtin its thru android phone
-
02-23-2011, 05:37 AM #3
I bend my prop several times,never had a problem.
New solas props even have different angles from the factory.
I always check my props which pitch angle they have,mostly there are small differences,but won't damage your pumpbearing.
-
02-23-2011, 11:32 AM #4
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Possible problem or just need repitched???
By philys21 in forum 4-Tec PerformanceReplies: 6Last Post: 05-30-2011, 09:58 AM -
impeller duct problem
By czoltak in forum Yamaha PWC Performance (4-stroke)Replies: 15Last Post: 04-08-2010, 10:20 AM -
Possible problems with new domes
By seajm in forum Yamaha Old School SkisReplies: 3Last Post: 07-17-2009, 11:14 PM -
Impeller install problems...
By aha in forum 4-Tec PerformanceReplies: 20Last Post: 03-16-2009, 10:52 PM -
2 possible problems!!
By golson in forum 4-Tec PerformanceReplies: 14Last Post: 07-09-2006, 11:40 AM
Interesting…. Post photos
GP1300R built for Harley Davidson...