Results 1 to 4 of 4
-
02-22-2011, 04:59 AM #1
How to power on the gauge cluster with engine off.
GP1200R 01. Actually this is a question rather than a how to. Does anyone know how to test the display with the engine off? I assume you need to remove the cluster and connect to a battery (which wires?) to do it. I'm trying to read the hours but my engine is apart at the moment.
-
02-22-2011, 06:25 AM #2
-
02-22-2011, 07:20 AM #3
Perfect thanks! Worked a treat.
I can't exactly make out the numbers as there is a bit of water clogged between the plastic and the LCD itself. Is there any point trying to rescue this unit? I know some of the Polaris guys were able to bring poor lcd units back to life just wondering if anyone attempted something similar
-
03-01-2011, 12:56 PM #4
- Join Date
- Oct 2010
- Posts
- 142
I'm curious to know as well. My screen works but its hard to read the numbers due to the build of condensations. How does it get in there anyway? My screen isnt cracked in any way.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
how to run on the trailer
By yammieguy in forum Yamaha PWC Performance (4-stroke)Replies: 10Last Post: 06-28-2015, 08:38 AM -
02 gp800r how do you take the gauge cluster face cover off?
By macGruber in forum Yamaha PWC Performance (2-stroke)Replies: 8Last Post: 10-26-2013, 06:33 PM -
How to get on the plane quicker????
By mrgc in forum Kawasaki PWC Performance (2-stroke)Replies: 6Last Post: 08-05-2010, 09:39 PM -
Time to get on the water, Problem with seal.
By xBigDaddyx117 in forum 4-Tec PerformanceReplies: 8Last Post: 04-01-2010, 06:09 PM -
how do i get the gauge cluster out?
By mxl16 in forum Sea Doo Open DiscussionReplies: 4Last Post: 10-11-2006, 12:02 AM
RS is right...was very difficult to get at it and get both sides on. The...
Where/how to check Yamaha SVHO...