Sl750 torque specs

[Rca1965]

I have purchased a 95 sl750 that has holed a piston on the previous owner, i have replaced the fuel pump with a mikuni 3 output pump to help it from happening again, does anyone have the torque specs for this engine needed to rebuild the cylinder. Thanks, Russ

[K447]

I think that info is posted in the Polaris Tech or FAQ sections.

More useful info can be found through my signature links

[Rca1965]

I think that info is posted in the Polaris Tech or FAQ sections.

More useful info can be found through my signature links

I looked there but all i could find is clearances, no torque settings.

[g.willits]

torque should be 28 ft-pds for the cylinder base nuts, 18 for the head nuts, and i think 18 for the exhaust bolts

[Rca1965]

torque should be 28 ft-pds for the cylinder base nuts, 18 for the head nuts, and i think 18 for the exhaust bolts

thanks g.willits, i just found it on another forum, the only difference was exhaust was 16 ft lbs,

[g.willits]

yeah, i was close

[xlint89]

Replacing the fuel pump is a start, but you will want to look into the other possible causes as well.

http://www.greenhulk.net/forums/pola...wn-basics.html

[Rca1965]

yeah, i was close

your 18 isn't necesarily wrong, just 2 different settings from 2 different people, think i'll torque it to 17, lol, thanks again.

[Rca1965]

Replacing the fuel pump is a start, but you will want to look into the other possible causes as well.

http://www.greenhulk.net/forums/pola...wn-basics.html

Thanks xlint89, alot of good info there.