Results 1 to 5 of 5
-
09-02-2005, 10:03 AM #1
- Join Date
- Aug 2005
- Location
- Salinas CA
- Posts
- 451
Engine Removal---What Special Tools
I`m pulling my motor. Will I need any Special Sea-Doo tools.
Like one for the drive shaft. Etcetera.
If so could I get the part #s so I can order them. Thanks.
Also any tips I can get would be very handy too. No manual on hand. I really cant afford more damage so any help is greatly appreciated. Thanks Again.
-
09-02-2005, 10:39 AM #2
Is this for the RXP? If so, you need the drive shaft removal tool (529 035 987) for sure. If you are replacing the SC clutch, you need the shaft holding tool (529 035 949) or a 1" spanner tool from a local auto store. If you are cracking the SC open, the support backing plate (529 035 947) is very helpful.
One tip: when putting the engine back in, attach the hot wire and 3 ground wires on the front of the engine before you lower the engine all the way into the hull. These are a bitch to attach when the engine is all the way in.
Have fun, I know I did
-
09-02-2005, 10:46 AM #3
- Join Date
- Aug 2005
- Location
- Salinas CA
- Posts
- 451
Yes it`s for my RXP. Thanks for your help.
It`s always better the second time I`m sure.
-
09-02-2005, 10:54 AM #4
Hey Franko If you just want to change the Sc Fan do you have to take it all apart including clutch?
-
09-02-2005, 10:55 AM #5
Angel, if you are just changing the SC impeller, you do not need to remove the clutch. But you still need the shaft holding tool and the support backing plate is really helpful.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
What Gaskets Are Needed For STX1100 Engine Removal?
By sjorge3442 in forum Kawasaki PWC Performance (2-stroke)Replies: 10Last Post: 07-15-2016, 04:29 PM -
what special tools from Yamaha are needed to tear down crankcase
By JoeyDFZS in forum Yamaha PWC Performance (4-stroke)Replies: 6Last Post: 07-31-2014, 06:20 AM -
engine removed what maintenece should be done
By jdogg in forum Polaris Open DiscussionReplies: 4Last Post: 03-05-2011, 02:02 PM -
removing pto coupler without special tool...any suggestions?
By MJE in forum Kawasaki PWC Performance (2-stroke)Replies: 5Last Post: 06-06-2010, 11:53 PM -
ok Riva stage one and RR exhaust install What special tools do I need??
By CarFanatic in forum 4-Tec PerformanceReplies: 4Last Post: 07-07-2006, 10:14 AM
Good that you got it sorted. Stock impeller on my GP had cavitation until...
My 2017 FXSVHO Cavitation /...