Results 1 to 10 of 23
Thread: Well...CDI...stator or both?
-
08-23-2009, 06:10 PM #1
Well...CDI...stator or both?
Coil tested at .6 ohm however there is .2 just through the probes...which puts it at .4 ohm which I think I read that .35 is good...so assuming this is good also...
Stator sections 5.5 Ohm....and .8 ohm
Hall effect sensors tested ok x 2 but one was like 775 ohms...?
Tested the brown wire trick....and 9v going to the brown wire to the stator still produced no spark...and when I checked for the voltage from the brown wire at CDI...I got nothing.
So....bad CDI....bad...stator "hall effect" section...or both?
M
-
08-24-2009, 11:36 AM #2
cdi
pre 99 domestics had stator issues,99 and up doesn't
-
08-24-2009, 02:58 PM #3
- Join Date
- Oct 2006
- Location
- Beaver Falls, PA
- Posts
- 281
What year ski? Later 2000-2004 need good battery voltage to the CDI while cranking. Holding the start button what is the cranking voltage on the red purples in the electrical box? Hold the start button for 15 seconds and what is your reading. Do not use a boost box or jump pack or charger on this test unless you plan to install one to use on the lake. If your readings are less than 10.5 vdc. Get a new battery. and retest on the brown wire.
-
08-24-2009, 03:49 PM #4
It's an 04 Virage....I'll go test battery voltage now..but it turns over very quickly... I had no power output on the brown wire..when testing directly from the CDI...
M
-
08-24-2009, 03:53 PM #5
While turning the ski over and the red/pur wire that connects to the CDI it was at 14.4 volts...
M
-
08-24-2009, 04:37 PM #6
twin
the late model twin cyl cdi's are bad about crapping out,probably dnue to them firing both cyl's at the same time
-
08-24-2009, 05:47 PM #7
Tx....I also added the 9 volt to the stator however and got nothing...the hall effect sensor also didn't test propery if I'm using the right test. As I rotated the engine I could see them change but one was at like 750 ohms...when it should have been less then 20 I think it what the test said...thoughts?
M
-
08-24-2009, 06:19 PM #8
anyone got a manual? I noticed the missing spot I got it the last time...and I can't get ahold of the CD I made.
M
-
08-24-2009, 06:58 PM #9
-
08-24-2009, 07:03 PM #10
Section on testing stator...coils etc. Trying to figure out why this thing lost spark all of a sudden. It's a 2004 Virage with the 700 in it
M
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
I give up on this ski.. No spark so now the stator or cdi is fried...
By Fenderjack in forum Polaris Open DiscussionReplies: 7Last Post: 07-27-2015, 06:11 PM -
CDI Ignition or Stator Problem
By breezey in forum Polaris Open DiscussionReplies: 6Last Post: 11-20-2010, 01:47 PM -
Nozzle or repitch or both ?
By mrbtd in forum Yamaha PWC Performance (2-stroke)Replies: 3Last Post: 04-23-2007, 03:44 PM -
Salt water maintenence- Flush, fog or both?
By seadoo951 in forum 2-Stroke PerformanceReplies: 14Last Post: 02-06-2007, 02:29 AM -
stator or cdi problem!!
By ugadawg131 in forum Polaris Open DiscussionReplies: 9Last Post: 12-07-2006, 12:46 PM
Aw crap
New SVHO Owner, couple of ?