Results 1 to 3 of 3
-
08-22-2009, 10:55 PM #1
Suggestions on how to Disassemble & Clean Pump
I picked up a locked up extended pump with drive shaft for real cheap. Pump extension seems to have shrunk and locked up on the impeller. I plan to use the impeller because it is in mint condition.
Any suggestions on how to remove the extension without damaging the impeller? The only thing that comes to mind is jig saw? I guess I'd rather not scrap the extension... if possible
Also, the pump was either in brackish or salt water, what is the best way to clean up all the white spots on the pump. They are either corrosion pits or barnacles.
-
08-23-2009, 01:52 AM #2
In my opinion,it doesn't look like the impeller is rusted to the extension. Is the stator locked up? (bearings)
Try to loosen the impeller (with an old drive shaft if need be)
The impeller does look recent,parts of the decal are stilll visible.
-
08-23-2009, 06:21 AM #3
have it bead or sand blasted
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
How to disassemble, clean, rebuild, and reassemble trim motors
By BlueFishCrisis in forum Polaris How To & FAQsReplies: 31Last Post: 04-25-2015, 05:55 PM -
Any Directions on how to install Pump Shoe rubber pieces?
By Dragdaddy71 in forum Yamaha PWC Performance (4-stroke)Replies: 3Last Post: 05-16-2013, 10:11 PM -
how to test my fuel pump on my msx 150 ???
By isaacv375 in forum MSX/MatrixReplies: 7Last Post: 05-01-2013, 10:39 AM -
stuck starter in flywheel housing. any suggestions on how to remove? thanks team.
By jhollander in forum Polaris How To & FAQsReplies: 6Last Post: 03-05-2012, 08:36 PM -
How to re-fit jet pump & trim on kawasaki 900zxi
By dippydi in forum Kawasaki PWC Performance (2-stroke)Replies: 0Last Post: 10-15-2010, 03:11 PM
Not at all. Every engine provides best power at lower elevations. The...
2022 FX SVHO ride plate upgrade