Results 1 to 5 of 5
-
08-16-2009, 07:16 AM #1
Help - Handle on front of hull... ??
Ok, so stripping my ski to paint and my mate decided to pull the handle off the front and snap the bolts as they were no doubt rusted.
Is there anyway to get to the inner side to to grab the nut on the inside so I can remove and replace the the whole assembly?
-
08-16-2009, 07:33 AM #2
handle
looks like your going to have to drill and re tap it .
e...
-
08-16-2009, 07:37 AM #3
Started to do that... but given how much it has rusted I don't think the female part of the thread will be much good either... so prefer to just change it all out if possible.
-
08-16-2009, 10:36 AM #4
I see this everytime someone tries to remove these.
http://www.greenhulk.net/forums/show...ghlight=boweye
http://www.greenhulk.net/forums/show...ghlight=boweye
-
08-16-2009, 03:56 PM #5
Awesome... thanks champ... much appreciated.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
white stain on outside of hull
By usaf_mike in forum Sea Doo Open DiscussionReplies: 18Last Post: 09-23-2011, 01:26 PM -
Working on bottom of hull...
By jkindt in forum Polaris How To & FAQsReplies: 6Last Post: 10-08-2010, 06:41 AM -
Working on bottom of hull...
By jkindt in forum Polaris How To & FAQsReplies: 4Last Post: 10-18-2009, 09:06 AM -
94 SL650 vent tube on top of hull, where the other end go?
By sparky0114 in forum Polaris Open DiscussionReplies: 3Last Post: 05-06-2008, 06:05 PM -
Coolant on Bottom of Hull
By JFizzleJR in forum 4-Tec PerformanceReplies: 2Last Post: 04-21-2007, 02:58 AM
So at sea level are you saying the stage 1 plus tune is pretty useless?
2022 FX SVHO ride plate upgrade