Search

Type: Posts; User: Pwnage1337

Search: Search took 0.00 seconds.

  1. Replies
    4
    Views
    517

    Did you open the bleed screw on the pump? You...

    Did you open the bleed screw on the pump? You should open the bleed screw on the pump and watch the oil run from the filter into the pump. keep the bleed screw open until you feel oil dripping out of...
  2. Thanks guys. We'll get it in the water soon and...

    Thanks guys. We'll get it in the water soon and check it out
  3. 1994 SL 750 - Synchronizing Mikuni Triple Rack Carbs

    While taking apart the Rack carbs, the screws that adjust the butterflies relative to each other had to be opened up to get all the carbs back on the rack after a rebuild.

    Unfortunately I did not...
  4. Got the ski fired up yesterday! It fired off...

    Got the ski fired up yesterday! It fired off pretty quick. Held the oil pump lever wide open to get the oil flowing to the carbs as quick as possible, because we replaced the oil lines.

    All three...
  5. I found some information stating that the Pro1200...

    I found some information stating that the Pro1200 used the 70gram spring which would be the 11mm one and should have between 11-18 popoff. I am going to give this a shot.

    Please chime if you have...
  6. The carbs I have here have a 2.0 seat size, with...

    The carbs I have here have a 2.0 seat size, with an accelerator pump. The springs that came out of them measure about 7.75mm long. The kit i purchased comes with this spring, what should the popoff...
  7. We are about 1100 feet above sea level here. It's...

    We are about 1100 feet above sea level here. It's amazing to me how many different jetting combinations were used by Polaris. I will give the jetting from post #7 a try since it's close to our...
  8. What's a good source for Keihin Jets? I'd like...

    What's a good source for Keihin Jets? I'd like OEM if possible, or a good quality aftermarket if that's what you guys are running.

    Thanks again

    Jeremy
  9. Thanks for the input. The PTO carb i took...

    Thanks for the input.

    The PTO carb i took apart had a 138 main, 50 mid, 68 low.

    Can i run this jetting? Otherwise i'll just order new jets. My guess is it would be a little fat in the mid...
  10. 1999 X45 to Keihin Carbs and 1050 Red Pipe Conversion

    Hey guys

    I'm helping a friend with his ski. It is a 1999 X45 with the 1200 and the Bing Carbs. Before we began we checked compression and pulled 125 on all three cylinders.

    Did a little...
Results 1 to 10 of 10