Search

Search: Search took 1.00 seconds.

  1. Replies
    6
    Views
    739

    With the valve cover off, reach in there with a...

    With the valve cover off, reach in there with a long screwdriver or a stick and just tap or bump the plastic guide which rests against the tensioner, this will release the tensioner and will apply...
  2. Replies
    14
    Views
    1,706

    I had the Worx sponsons on my GP1800 for two...

    I had the Worx sponsons on my GP1800 for two rides before removing them. They were very aggressive in low position or tame in upper position. I noticed that the ski was a bit less stable with a...
  3. Replies
    53
    Views
    21,021

    Sticky: Can also fill the intake grate with an epoxy...

    Can also fill the intake grate with an epoxy filler and retain the factory rubber strip, then seal it up with silicone, it really helped with cavitation. Transom leaking small amounts of water into...
  4. Replies
    86
    Views
    8,855

    I prefer to put it in the water and let it get...

    I prefer to put it in the water and let it get warmed up a bit, make sure the ski is level, then just let it idle for 30 seconds, shut it off and wait one minute, now check the oil. If you add or...
  5. Replies
    118
    Views
    33,743

    Pictures of Volute and upgraded shaft.

    The talked about volute which is pressed into the front half of the two part S/C housing...
    http://www.greenhulk.net/forums/attachment.php?attachmentid=411626&stc=1

    Drilled through the housing...
  6. Yes, GP seats will fit perfectly on 2015 and 2016 vx series hulls.

    http://www.greenhulk.net/forums/attachment.php?attachmentid=408664&stc=1http://www.greenhulk.net/forums/attachment.php?attachmentid=408665&stc=1http://www.greenhulk.net/forums/attachment.php?attachmen...
  7. Replies
    584
    Views
    230,850

    Sticky: Fizzle Y1000, plenty of room for BOV line fitting...

    Fizzle Y1000, plenty of room for BOV line fitting at front of intake...
Results 1 to 7 of 7