Search

Type: Posts; User: kingofl337

Search: Search took 0.00 seconds.

  1. Replies
    11
    Views
    911

    To wrap this up, I ended up using Muriatic Acid...

    To wrap this up, I ended up using Muriatic Acid to clean the aluminum off the cylinder liner. When I finished there were no scratches I could catch with my nail. I dropped a ball hone down both...
  2. Replies
    11
    Views
    911

    The motor is barely a year old since the full...

    The motor is barely a year old since the full rebuild. So, I think it is safe to say they would have been shipped like that. I highly doubt that much surface pitting would have been created in such a...
  3. Replies
    11
    Views
    911

    Should I pressure test the cooling system to make...

    Should I pressure test the cooling system to make sure it wasn’t the head gasket?

    So, being an engine builder, I assume you wouldn’t cover this under a warranty if it was you. I just found out...
  4. Replies
    11
    Views
    911

    My boroscope just came in the piston wash is the...

    My boroscope just came in the piston wash is the same for both cylinders. Only one shows damage.
    ...
  5. Replies
    11
    Views
    911

    This is what I’m concerned...

    This is what I’m concerned http://greenhulk.net/forums/blob:http://greenhulk.net/3d93b46d-8384-46ca-bd4d-a8ac367fd3e2about. Though as time passes I’m concerned Full Bore is probably MIA until fall so...
  6. Replies
    11
    Views
    911

    Is the video bad, not enough info? I'm trying...

    Is the video bad, not enough info?

    I'm trying to get in touch with Full Bore Racing to see if this is something they will cover under warranty. I just wanted to know what you guys think.
  7. Replies
    11
    Views
    911

    Cause of death on 720 GTI?

    Hi everyone I’m looking for help as to the cause of death on my 720 GTI Single Carb. Oil system was working, carb clean, rotary valve was tight and exhaust bolts gaskets seemed tight. This motor had...
Results 1 to 7 of 7