Search

Type: Posts; User: K447

Search: Search took 0.11 seconds.

  1. Well, are you sure you turned the timing wheel in...

    Well, are you sure you turned the timing wheel in the correct direction for advance?

    Typically the factory groove is good for most of ten degrees, if not all of ten degrees. But the timing ring...
  2. 1800 RPM idle out of the water is probably too...

    1800 RPM idle out of the water is probably too low.

    Should be well over 2000, somewhere in the 2500-ish range.

    Why did you need to advance the flywheel timing?
    Is the CDI you installed...
  3. Does it have plastic hull extensions on the back...

    Does it have plastic hull extensions on the back lower edge?

    The Hurricane hull is known to porpoise at speed. Riding it on left or right chine (body weight towards on side or the other) reduces...
  4. If all the other bullet connectors from the...

    If all the other bullet connectors from the stator and CDI are paired up properly, the remaining two ‘green’ can be connected together.

    Risk of damaging CDI or stator is very low as the only...
  5. Download the wiring diagram...

    Download the wiring diagram for your model.

    Read about how the ignition update kit differs from the factory wiring. You will be using a combination of the factory wiring and the update kit wiring...
  6. Found this thread with some photos...

    Found this thread with some photos
    http://greenhulk.net/forums/showthread.php?t=243841&p=2681453&viewfull=1#post2681453

    Metal shield for the wires?...
  7. Perhaps someone on here can post a photo of how...

    Perhaps someone on here can post a photo of how the stator wire bundle is supposed to be routed inside the flywheel housing?

    The sheath can be trimmed if it must be. Somehow I am wondering if the...
  8. Not understanding what you would be cutting? ...

    Not understanding what you would be cutting?

    Photo perhaps?
  9. Is the stator wire retaining clamp missing?

    Is the stator wire retaining clamp missing?
  10. This post and video might help. There is a...

    This post and video might help.
    There is a single tiny magnet bonded to the edge of the timing ring.
    http://greenhulk.net/forums/showthread.php?t=280378&p=3029261&viewfull=1#post3029261

    ...
  11. Read the linked material, it will answer a lot of...

    Read the linked material, it will answer a lot of questions.

    The timing ring is a small plastic part that bolts to the inside center of the flywheel. Embedded into the plastic rim is a tiny magnet...
  12. Do you know whether the CDI you purchased is...

    Do you know whether the CDI you purchased is configured for High Start or regular ignition base timing?

    The difference is described via this link, along with lots of other useful info.
    Look in...
Results 1 to 12 of 12