Search

Type: Posts; User: JohnScott

Search: Search took 0.00 seconds.

  1. I am looking for a throttle control lever. Do...

    I am looking for a throttle control lever. Do you have one available? if so, what are you asking for it? Thanks.
  2. I have the same issue with the same part number. ...

    I have the same issue with the same part number. Did you find a replacement that works? If so, please supply the info. Thanks.
  3. Replies
    2
    Views
    297

    1995 SL 650 STD, towing precautions?

    I am new to this as just purchased a '95 SL 650 STD. Is there something I must do to this ski before towing? Nothing was mentioned in the owners manual. Thanks.
  4. I had the same problem with oil not reaching the...

    I had the same problem with oil not reaching the end of the lines. I removed the oil pump from the block, chucked the pump drive shaft into my drill and ran it in reverse. The oil slowly moved up...
  5. Replies
    0
    Views
    364

    Engine start after modifications

    I recently purchased a '95 Polaris SL650 STD. I am new to the jet ski scene and have enjoyed taking on this project. Following advice I read online, I just finished rebuilding the carbs, replaced...
  6. Replies
    7
    Views
    527

    Thanks for your input. I just reconnected the oil...

    Thanks for your input. I just reconnected the oil injection. What say make sense so I'll give it a shot.
  7. Replies
    7
    Views
    527

    Abandon oil injection question

    On a 1995 Sl650, do I have to remove the oil injection gears and shaft that drives the pump if going to pre-mix? This a new/used ski for me and I plan to rebuild next winter. Can this wait? Thanks.
  8. Replies
    2
    Views
    521

    Abandoned oil injection "95 SL650

    I am new to jet ski's so looking for any advise I can get. I am rehabbing a "95 SL650 and wish to abandon the oil injection system. Will I do damage to the engine if I do not remove the internal...
  9. Replies
    0
    Views
    462

    650 sl fuel petcock

    Looking for the Seadoo part number that will serve as a substitute for the Polaris fuel petcock. Anyone out there use the Seadoo part?
  10. Replies
    238
    Views
    61,605

    Sticky: I am currently going through newly acquired 95...

    I am currently going through newly acquired 95 650 sl and have found the Clymer shop manual helpful with specs./ torques.
Results 1 to 10 of 10