Search

Search: Search took 1.00 seconds.

  1. That valve looks very much like the Antelco ball...

    That valve looks very much like the Antelco ball valve I use. I suspect the same valve is sold under multiple brand names, and not just for ‘irrigation’.

    One of the first Antelco valves I found...
  2. Replies
    4
    Views
    328

    Saltwater ski for sure

    Saltwater ski for sure
  3. That larger line is the oil pump supply line. It...

    That larger line is the oil pump supply line. It feeds the pump. Why do you want to replace the oil pump with a block off? The oil pump is super reliable. The lines, however need periodic...
  4. Replies
    5
    Views
    248

    Could very well be the midshaft bearings since...

    Could very well be the midshaft bearings since nobody seems to know about greasing them.
  5. Replies
    22
    Views
    1,089

    moneypit 1, moneypit 2, moneyabyss, and...

    moneypit 1, moneypit 2, moneyabyss, and WTFmywalletisempty
  6. Replies
    7
    Views
    316

    That's quite a bit of turning over to get oil to...

    That's quite a bit of turning over to get oil to the carbs. I always remove the pump and turn it with a drill to get oil through the lines. The pump turns CCW.
  7. Replies
    11
    Views
    708

    Agreed. Plugs look good, and it may have not been...

    Agreed. Plugs look good, and it may have not been fogged very well.

    Some folks quick-fog : aka whilst running, blast the aerosol oil down the intake until it snuffs the engine out, and this is...
  8. Replies
    11
    Views
    708

    ....which means somebody didn't fog properly for...

    ....which means somebody didn't fog properly for storage. Imagine your valve stems also looking like that...
  9. I wouldn't run the DF 14/20 on your current...

    I wouldn't run the DF 14/20 on your current set-up. If you convert over to the HO pump from the 05+ years, you may be able to turn it reasonably well. Even then, it could require a repitch.

    Pretty...
  10. Replies
    6
    Views
    456

    My guess, you dropped one of the washers down in...

    My guess, you dropped one of the washers down in the crank case when putting the piston on. Once you finally opened the engine up, there was enough up draft to suck the washer off the bottom of the...
  11. Replies
    1
    Views
    309

    Jet ski mechanic in michigan

    Hey guys,

    I have (2) yamaha waverunners. 2002 gp800r and a gp1200r. They both quit working and would barley run in the water. I was refered to a mechanic who got the 800 running decent prob 5 to...
  12. 93 Yamaha VXR pro leaking water from behind the drive shaft.

    So I got a 93 vxr pro that I got running and now runs amazing. But the problem is that its leaking water behind the seal for the drive shaft between that bearing and the hull there. Im curious...
Results 1 to 12 of 12