Search

Search: Search took 1.00 seconds.

  1. Replies
    12
    Views
    503

    You're very welcome, actually i was just thinking...

    You're very welcome, actually i was just thinking since your ski is a 2010 and the voltage regulator is in the back next to the battery you might be able to plug the 2020 stator directly into the...
  2. Replies
    12
    Views
    503

    What i ended up doing was cutting the new style...

    What i ended up doing was cutting the new style connector off of the 2020 stator and bought a new older style connector and pins and crimped them on the wires and then it plugged right into the...
  3. Everyone removing their supercharger should own...

    Everyone removing their supercharger should own an E8 wrench, for $15 its not worth dealing with a stripped bolt https://www.jbtools.com/vim-tools-wt0810-torx-box-wrench/
  4. Replies
    21
    Views
    964

    The impeller coming unthreaded from the jetpump...

    The impeller coming unthreaded from the jetpump would definitely allow the hull to fill with water, it pushes the driveshaft forward and creates a gap in the hat and carbon seal letting the water in,...
  5. Replies
    6
    Views
    814

    The next upgrade I would do would be a 4" air...

    The next upgrade I would do would be a 4" air intake and a tune for the computer, without the tune you're not going to see a performance improvement from any added parts since you'll be stuck at the...
  6. Replies
    97
    Views
    11,007

    I think its time for seadoo to start building...

    I think its time for seadoo to start building their watercraft with fiberglass and gelcoat again!
  7. Replies
    12
    Views
    2,368

    You're very lucky you found the carbon seal issue...

    You're very lucky you found the carbon seal issue before it sank! Take it back to the dealer for an engine alignment and a new carbon seal
  8. Replies
    23
    Views
    4,972

    Misfire

    I have been chasing the same issue on my ski (2011 RXTX) as well, it doesn't have a dead miss but more like a cough at around 2800 to 3800 rpm anything under or over it absolutely fine, every other...
  9. Replies
    7
    Views
    3,433

    It's never good when your engine let's go, sorry...

    It's never good when your engine let's go, sorry to hear that happened to you. SBT engines have come along way and should be a good option, but you should contact slow91 (Chris) here on the forums,...
  10. Replies
    82
    Views
    14,203

    Poll: WD-40 is petroleum based and will eventually...

    WD-40 is petroleum based and will eventually destroy all the rubber components in your engine bay! You should use nothing but a pure silicone spray, I have used this stuff for a very long time and in...
  11. Replies
    3
    Views
    693

    Your first picture looks to be the ceramic...

    Your first picture looks to be the ceramic washers and the 2nd looks like the metal washers
  12. Replies
    8
    Views
    838

    Sounds like a good plan to me except you want to...

    Sounds like a good plan to me except you want to use the 42# injectors, the 48's will run your engine very rich, the 260's come with 48's because they have more ignition timing and need the extra fuel
  13. You can run the 38's if everything else is left...

    You can run the 38's if everything else is left stock, if you decide to install a 4" air intake you would need the 42's
  14. When i pressure tested my intercooler i put...

    When i pressure tested my intercooler i put compressed air to the water inlet side and stood the intercooler upright and filled the air part of the intercooler with water, that way you would see any...
  15. The stock flywheel bolts do fail but they only...

    The stock flywheel bolts do fail but they only seem to be failing for the guys running their machines at a higher rpm, seems to be anything over about 8500 for an extended amount of time.
  16. Replies
    276
    Views
    39,466

    You did a really nice job putting the video...

    You did a really nice job putting the video together, it is awesome! And i love the music you chose, what's the name of the track?
  17. Replies
    9
    Views
    792

    You'll have to bring it to the dealer so they can...

    You'll have to bring it to the dealer so they can reset the maintenance light for you, you should have your supercharger rebuilt before any damage occurs
  18. Replies
    9
    Views
    1,594

    I have the Riva catch can on my 2011 rxtx and...

    I have the Riva catch can on my 2011 rxtx and have no complaints, it does work and i have to drain it occasionally, i like that it keeps all of the blow-by gases out of the intake so they are not...
  19. Replies
    28
    Views
    8,949

    You should go for it Jerry, you won't regret it!

    You should go for it Jerry, you won't regret it!
  20. If you have some money to spend i would get a...

    If you have some money to spend i would get a riva Gen 3 Intercooler so you don't have to worry about it anymore, i bet the factory ones will fail again and again, especially in the salt water, mine...
  21. Good choice going with the R&D grate, you won't...

    Good choice going with the R&D grate, you won't be disappointed at all, i have it on my 2011 rxtx and love it
  22. The R&D Grate is the best in my opinion, it keeps...

    The R&D Grate is the best in my opinion, it keeps the ski hooked much better than the rest
  23. Replies
    44
    Views
    22,736

    Your Instructional is great, its better than any...

    Your Instructional is great, its better than any seadoo ibr video i've ever watched!
  24. Replies
    9
    Views
    1,369

    I've used the K&N filters in the past and they...

    I've used the K&N filters in the past and they work just as well as the oem filters do, i have never found any problems using the brp filters and they cost less so i would just stick with the factory...
Results 1 to 24 of 24