Search

Whatever you do, make sure on the electronics/fuel side the ski thinks it is the same as the ecu you use. If you use a 300 ecu, use 300 injectors, intake manifold, fuel presure, etc. Check camshaft...

You may want to look at getting a hitch hauler and single trailer. Then just carry a beach cart to move them around. It sounds like more space but they pack up really well.

Sean

Skat 155 or kawi 155?

Sean

Nope, the ultras are 155mm or 160mm and the stx is 148mm

Sean

pics? what engine is it for?

Sean

Beerdart stuck a 4tec in his.

Sean

Nice score Steve! I have been looking on an off for one for a while.

Sean

Going to need to know more about what ski it is.

Sean

Im not assuming anything. Speaking from experience, even on the neglected motors that I have torn down where the hulls sat with water in them or on the water in floating docks, corrosion inside the...

Any motor I have opened has been damn near spotless inside, even neglected ones. Unless you sink the ski, crack a head, or pop an oil cooler you aren't really going to get water in the cases. The...

Nope, sorry.

Sean

Start by adding a shim/washer between the hull mounts and the plate at the rear to adjust the angle of the plate.

I ground the mounts for the plate down so the front of the plate was flush or...

Thanks, I am reasonably happy with how they turned out. A couple notes on them, make sure you round any edges on them, bashing your shin on a sharp piece of aluminum under the water line sucks ass. ...

What is your goal for the tabs?

Sean

Yep, mine is all doo, I mostly meant to look for where I have mine mounted and attached.

Sean

Take a look at my kawidoo thread, there are (or should be) some pictures of the vts install.

Sean

easiest method would be to use a yamaha quick trim setup or set it up as an auto drop.

Sean

Ok cool, its been a while since I played with the stock setup. My megasquirt primes on key-on so I wasn't 100% sure. On my 12f, I used to just bump the starter button and let the pump prime if I had...

Its been a while since I ran the stock ecu but if my memory is right, the fuel pump only kicks on when you hit the starter button for a few seconds.

Sean

Triple Fuel Pickup Sold

Sean

Yeahhhhh we can't see anything from the pictures.


What jet pump are you running? It may be producing a more rapid engine decel when the pump loads back up.

Sean

No need to apologize, we all gain when people share their experience.

Sean

Wax did a limited run so they may or may not be any left.

My only complaint with the bed plate is that the clearance on the motor mounts is a little tight but that could be due to the rhaas...

The only aftermarket tunes that I know of that riva did for the stx were race gas only.

One set was for the supercharges motors, and one set was for the high compression motors.

Sean

I think the immobilizers are different, the cam position nub is in a different spot relative to the crank angle on the early vs later models. The temp sensor curves are also different early vs late...