Search

I have been thinking about this as well and interested in the findings / results.

Yup. I actually used the Skat 14 vein setback pump with Skat twin on my 2009 FZ. That thing made a huge improvement! On my 14 I used OEM 160 pump.

In the video I saw, they stated larger diameter AND with more teeth for the 2021.

I used to get about 50 - 90+ hours out of my clutches with ET18 or OEM SVHO wheel revving between 9000 - 9700 rpm with a twin impeller and always gave it hell at the races, testing for the races, and...

Nice setup!

That's sweet! Surprised SeaDoo took this away from the display options. I always like to see engine temp and will be interested when this is released.

I am happy with the stock grate, but also interested to hear how others like the WORX grate. I personally like Riva products best and have been waiting for them to release their ST3 grate, but so...

Yes I did.

Ouch! That sucks.

Nice idea and location.

So...... After putting everything together using the transducer epoxy, new transducer, and checking all connections and fuse, even thought depth showed intermitely while on the trailer it worked...

Correct, thank you for listening. :)

Ski only has 25 hours, garage kept, and well taken care of so no corrosion. I did try a different fuse and same issue. At this point, since when I move...

No, this happened before installing the module. All module functions work as they should.
Going to take apart the connector for depth finder on ski wire harness side to masks sure all is OK and...

Thanks, this is certainly helpful, but the issue is not that it reads incorrectly. It does not show "Depth" on the dash at all when I scroll through the options.

I purchased this epoxy for my...

Yup. See, it is epoxied to the hull. Mine was also hard to remove, but got it out, but do not advise doing so unless you have to. This method is common on boats. Not sure why they dont use the gel...

Nope, I did not install it. This came factory.
Ok, thanks!

Thanks. I saw that part shown in other model skis, but mine does not use it. The transducer transducer is epoxied in place.

As mentioned, when I scroll through the display (It always shows rpm,...

Thanks. I have heard about coolant in some model, but not sure if it is mine and where that coolant would be? It has a base that was glued to the hull and transducer that was epoxied in (bottom of...

Last time out on my 2019 SeaDoo GTX 300 Limited, I noticed that my depth finder option was not displaying on the dash while scrolling through the display options.
Later as I was scrolling through...

Sounds like you need to come to Florida.. :) This weekend is looking good with low 80's for a high and we have some great areas to ride!

For simplicity and because I am impatient, I bought the...

Looks great Keith! Nice clean setup and great speeds with drag setup! ;)


N/A cams give zero top speed, only help with the low to mid range power.

I opted for the Riva and really like them.
After having T-Bolt clamps pop off, especially at the charger side of SeaDoo since it is a smaller clamping surface, I personally like GOOD worm clamps...

You can wave jump any ski.
But I wouldn't wave jump any 4 stroke ski. Buy a Wave blaster, stand up, or older GPR for that.

All my skis tend to get rear exhaust. It is louder, but since it goes out the back and not in the pump area it is not so bad. I took my kids and wife out on the ski all the time and had rear exhaust...

I was wondering the same thing. Looks like they incorporated the 160 wear ring into the pump with replaceable wear ring, but the pump/stator section tapers down. Be nice to see pics inside the pump...