Search

Type: Posts; User: Turbo831

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Replies
    1
    Views
    142

    07 RXP Holeshot issue

    I have something going on with my 07 RXP. From idle to 3000 rpm anytime I pull full throttle the ski revs to around 5k rpm and then feels like it hits some kind of limiter, rpm will bounce between...
  2. Replies
    3
    Views
    184

    Thanks, I am running a Lucky 13 to keep rpms...

    Thanks, I am running a Lucky 13 to keep rpms under 8300. I plan on doing flywheel bolts, springs and retainers over the winter. Just trying to get the hole shot launch under control so I'm not...
  3. Replies
    3
    Views
    184

    07 RXP Prop advice

    Need some prop advice for my 07 RXP, currently running a Solas 15/21 with 3-4mm added to the trailing edge. My problem is that my if I hit full throttle from rest it just bounces off the rev...
  4. Replies
    12
    Views
    1,140

    FS - Parts Price on the injectors?

    Price on the injectors?
  5. Thread: Wtb srx 15/22

    by Turbo831
    Replies
    1
    Views
    281

    WTB Wtb srx 15/22

    Looking for a SRX 15/22 to use as a spare prop if anyone has one laying around.
  6. Replies
    1
    Views
    174

    Thread on powering gauges off switched power with...

    Thread on powering gauges off switched power with pics and wiring diagrams:

    http://greenhulk.net/forums/showthread.php?t=192244
  7. Speedometer will only display to 70, no...

    Speedometer will only display to 70, no electronic limiters on top speed on the older skis, just a rev limiter.
  8. Replies
    35
    Views
    2,486

    Good post on how to route the lines, it's how I...

    Good post on how to route the lines, it's how I did mine.
    http://greenhulk.net/forums/showthread.php?t=260405
  9. Replies
    35
    Views
    2,486

    If you look at the install instructions from Riva...

    If you look at the install instructions from Riva it is located under the assembly lid, it is replaced with a billet block in the kit. I think the Riva regulators are rebranded Edelbrock, you can...
  10. Replies
    35
    Views
    2,486

    If it has an RRFPR then the stock pressure...

    If it has an RRFPR then the stock pressure regulator should have been removed, you will need a pressure regulator in the fuel circuit.
  11. Thread: Help!

    by Turbo831
    Replies
    15
    Views
    1,257

    15/19 is for a rev limit higher than stock, if...

    15/19 is for a rev limit higher than stock, if you're running the stock limiter you will want the 15/22.
  12. Replies
    11
    Views
    916

    I run the Riva RRFPR in my 07 RXP:...

    I run the Riva RRFPR in my 07 RXP:
    https://www.4-tecperformance.com/index.php?main_page=product_info&cPath=345_375_413&products_id=1307
  13. Replies
    127
    Views
    12,824

    http://greenhulk.net/forums/attachment.php?attachm...

    http://greenhulk.net/forums/attachment.php?attachmentid=461410&stc=1
    It's the Vt-Pk (violet/pink on diagram, Riva calls it purple/red) to fuel pump off fuse #18
  14. Replies
    5
    Views
    477

    In my opinion 07's look better without all the...

    In my opinion 07's look better without all the decals:
    http://greenhulk.net/forums/attachment.php?attachmentid=460773&stc=1
  15. Replies
    1
    Views
    223

    07 RXP TPS Calibration

    I converted my 07 RXP over to aftermarket bars and finger throttle and had to shim out the throttle a little to get the throttle to open fully, afterward I was playing around with my Maptuner monitor...
  16. Replies
    4
    Views
    459

    Did a few test runs with the cone this week, I am...

    Did a few test runs with the cone this week, I am still at the limiter and same speed so will have to add some more to the prop. Did have two times around 6-7k rpm steady cruise were my rpms dropped...
  17. Replies
    4
    Views
    459

    Were at 12.2 at 8200, 58# base with reference...

    Were at 12.2 at 8200, 58# base with reference line attached. Only did two short runs though before it started to rain.
  18. Replies
    4
    Views
    459

    Lucky 13 cone advice

    Bought a Lucky 13 cone to try this year on my 07 RXP, last year I was running 8100 rpm with a 15/21 bent to a 15/22. Since then I have added a 137+4, F1000, exhaust spacer, RRFPR and removed the FA....
  19. Replies
    3
    Views
    367

    I did get my iPhone 5 to connect to logger but...

    I did get my iPhone 5 to connect to logger but then it says validating user on server and times out after a few minutes. Anyone still using these know a contact I could talk to at vtech about this? ...
  20. Replies
    3
    Views
    367

    I’ve tried calling and emailing them but received...

    I’ve tried calling and emailing them but received a recording on the phone so don’t know if they’re shut down for the crisis or what, just want it to work for this year then will upgrade to map tuner
  21. Replies
    3
    Views
    367

    Vetch iOS logger

    Bought an ions vtech logger off a board member and am wondering if anyone has any experience with these? I have an old iPhone 5 to use with it and have managed to connect to the logger however after...
  22. Replies
    2
    Views
    504

    FS Still have this? Might be interested

    Still have this? Might be interested
  23. Replies
    3
    Views
    404

    Thanks for the reply, that's what I was wondering...

    Thanks for the reply, that's what I was wondering about. My current setup worked fine last year so I will just stick with the single line for now. Were you running an 08+ type exhaust on your 05 or...
  24. Replies
    3
    Views
    404

    RXP Water Routing Question

    Have a question on the water routing on my 07 RXP. Previous owner upgraded ski with an 08 style waterbox and XS type intercooler, ski has ran fine with this setup without any issues, I am changing...
  25. Replies
    14
    Views
    1,214

    FS - Parts Payment sent for impeller

    Payment sent for impeller
Results 1 to 25 of 31
Page 1 of 2 1 2