Search

Type: Posts; User: Turboted

Page 1 of 8 1 2 3 4

Search: Search took 0.40 seconds.

  1. The easiest way to pull the pto.. cover is with...

    The easiest way to pull the pto.. cover is with the engine out and it sitting upright with the cover facing up. When putting in back together the starter drive will sometimes get in the way...so...
  2. Replies
    4
    Views
    107

    The rear pto cover has a pressure valve in it and...

    The rear pto cover has a pressure valve in it and it screws in from the bottom of the pto cover.. if that valve sticks you will have an oil pressure problem..sometimes they have a 10mm nut on...
  3. Replies
    12
    Views
    227

    Press the mode button 5 times for codes...i would...

    Press the mode button 5 times for codes...i would run a compression check on the motor to make sure you have good compression...sea doo had had some issues with ecu on those models too...
  4. Pull the motor and take the pto cover off and...

    Pull the motor and take the pto cover off and clean it all out...
  5. Replies
    6
    Views
    192

    He's the owner of this web site.. he rebuilds sc..

    He's the owner of this web site.. he rebuilds sc..
  6. Replies
    6
    Views
    192

    You didn't send it to jerry......

    You didn't send it to jerry......
  7. Replies
    5
    Views
    123

    Sounds like a defective fp...i ordered one on...

    Sounds like a defective fp...i ordered one on ebay that did the same thing...wasn't putting out enough fuel...
  8. Replies
    3
    Views
    123

    I have a 185 sc...needs rebuilt tho...

    I have a 185 sc...needs rebuilt tho...
  9. Replies
    3
    Views
    123

    The 155 does not have a sc...

    The 155 does not have a sc...
  10. Replies
    5
    Views
    150

    I think if you press the mode button 5 times it...

    I think if you press the mode button 5 times it will give you a code...if it has a hard code...
  11. Replies
    5
    Views
    150

    Do the gauges work....???

    Do the gauges work....???
  12. Replies
    8
    Views
    190

    Hmm is the gas any good...??? Maybe water in...

    Hmm is the gas any good...??? Maybe water in it...??? Compression test...???
  13. Replies
    8
    Views
    190

    You replaced the ecu....???

    You replaced the ecu....???
  14. Replies
    8
    Views
    190

    Did u check the fuel pressure...???

    Did u check the fuel pressure...???
  15. Replies
    1
    Views
    157

    Exhaust valves are hollow...they have a 72 on the...

    Exhaust valves are hollow...they have a 72 on the top...the better ones have a 75 at the top....bolts on the flywheel are weak ....also the sc washers...good machine other than those 3 issues...
  16. I think the early models had problems with the...

    I think the early models had problems with the oil filter cap leaking...the earlier models were plastic and the later ones are metal...so might want to start there...???
  17. Replies
    4
    Views
    141

    Thats for fogging the motor before storing...

    Thats for fogging the motor before storing...
  18. check to see if the injectors are spraying fuel...

    check to see if the injectors are spraying fuel when cranking over...I think that year had a problem with ecu...
  19. Thread: Rxp injectors

    by Turboted
    Replies
    1
    Views
    104

    Yes....same injector..

    Yes....same injector..
  20. Replies
    11
    Views
    474

    A bad map sensor will make the ski do all sorts...

    A bad map sensor will make the ski do all sorts of weird stuff...especially if it gets water in it...ecu tooo...???
  21. Replies
    2
    Views
    169

    Broken crappy 072 exhaust valves.im guessing...

    Broken crappy 072 exhaust valves.im guessing...
  22. Replies
    3
    Views
    795

    FS 2020 gp1800r...11099....???

    Just saw this post...dealer posting in muskogee Oklahoma 2020 gp1800r for 11099.00 ??? Are the new ones that cheap...???
  23. Replies
    0
    Views
    112

    WTB Looking for a set of oversized pistons..

    Looking for a set of pistons for a sc motor. Need to be 25 or 50 over.
  24. WTB - Parts Got one....2010 rxt...interested...???

    Got one....2010 rxt...interested...???
  25. Replies
    25
    Views
    1,932

    It has a bad bearing on it...that's why the sc...

    It has a bad bearing on it...that's why the sc wheel is rubbing on the housing...needs rebuilt...send it to jerry...he can fix it for you...
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4