Search

Type: Posts; User: HDAV

Page 1 of 8 1 2 3 4

Search: Search took 0.24 seconds.

  1. Replies
    3
    Views
    156

    I have one been on ski nearly 40 hours, fell off...

    I have one been on ski nearly 40 hours, fell off once 🤬

    itís cheaper for a reason....... might as well go straight for a fizzle and BoV!


    https://www.4-tecperformance.com/images/fizzle.png...
  2. Replies
    2
    Views
    91

    Not an issue I have seen check the ecu end in...

    Not an issue I have seen check the ecu end in case of corrosion or dry joint on ecu. The coupler looks clean? May need to roll motor over and see if coil is reacting.
  3. Replies
    6
    Views
    321

    SVHO are easier to extract than SHO due to oil...

    SVHO are easier to extract than SHO due to oil pan design. 5 min should get the oil
    warmed enough to flow as long as it’s not so cold outside. Doing it in winter run ski longer or for 5 min then...
  4. Replies
    6
    Views
    208

    Any fault codes? Could be a boost leak, bad...

    Any fault codes? Could be a boost leak, bad clutch, Misfire bad injector bad thrttle
    body

    does it pull hard to 6500 or struggle to get there?

    is the prop and housing in good condition?
  5. Thread: Fx SHO sponsons

    by HDAV
    Replies
    0
    Views
    67

    Fx SHO sponsons

    Found some old stock new R&D sponsons that should fit my fx SHO 2008 they were designed for the FZ series anyone know how they compare to worx or riva on the old SHO I have just fitted an old stock...
  6. Any progress? Have you cleared the fault code?

    Any progress? Have you cleared the fault code?
  7. Replies
    12
    Views
    448

    I think the manual is trying to explain what...

    I think the manual is trying to explain what happens when you grab both levers.
  8. Replies
    1
    Views
    51

    Ok so the vx is based on the MR-1 motor and is...

    Ok so the vx is based on the MR-1 motor and is very reliable if maintained and often do very high hours as a rental ski.

    Donít see how you are going to get the plug out without taking the head off...
  9. Replies
    8
    Views
    219

    The damp plug is a sign of water in the coil...

    The damp plug is a sign of water in the coil well, dry the coil and plug and Try again could be a bad coil, but much cheaper to replace all 4 plugs.
  10. Replies
    3
    Views
    282

    There is a seller of the sprag bearings however...

    There is a seller of the sprag bearings however yet to hear of anyone successfully replacing the sprag bearing and getting anything like the lifespan of a new factory fresh assembly. If you are...
  11. Replies
    6
    Views
    242

    Cable should be covered by warranty if out of...

    Cable should be covered by warranty if out of warranty once the cable has had water inside it will fail, might as well replace while you have it apart
  12. Replies
    1
    Views
    183

    What year ? have a read here...

    What year ?

    have a read here http://greenhulk.net/forums/showthread.php?t=215045
  13. Replies
    10
    Views
    431

    You don’t want plastic the Yamaha housing is a...

    You don’t want plastic the Yamaha housing is a great piece of engineering dismantle the pump and inspect/check clearance. Also you can check for leaks by adding water to hull with bungs in and look...
  14. Replies
    10
    Views
    431

    Water in hull?

    Water in hull?
  15. Replies
    3
    Views
    208

    arrived in uk pretty quick when I ordered mine a...

    arrived in uk pretty quick when I ordered mine a couple of years ago
  16. Replies
    11
    Views
    652

    replacement battery should come with a spacer....

    replacement battery should come with a spacer. If it doesn’t make one to fit
  17. Replies
    3
    Views
    208

    For $50 get the tool ...

    For $50 get the tool

    https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.co.uk%2Fulk%2Fitm%2F192642709324
  18. Replies
    73
    Views
    6,097

    interesting... how is it different ?

    interesting... how is it different ?
  19. Replies
    12
    Views
    1,003

    Surprised if those “mods” would cause an...

    Surprised if those “mods” would cause an issue.... what is the error code? How many hours? Does water flow freely from all pissers? Is thermostat working correctly? What rpm and speeds are you seeing...
  20. Thread: 98 GS pump seal?

    by HDAV
    Replies
    9
    Views
    624

    This a suitable gear oil?...

    This a suitable gear oil? http://www.lucasoil.co.uk/images/documents/TDS_Lucas-Synthetic-SAE-75W-90.pdf
  21. Replies
    8
    Views
    896

    I had forgotten about this too, seems it’s no...

    I had forgotten about this too, seems it’s no longer available either, so not sure what happened there....vapourware or did they get a cease and desist notice ?
  22. Thread: Remote Oil Filter

    by HDAV
    Replies
    20
    Views
    3,173

    Pump bearings.... but no nipple on there, perhaps...

    Pump bearings.... but no nipple on there, perhaps you could add one?
  23. Replies
    29
    Views
    1,474

    Sorry to be the bearer of bad news but this is...

    Sorry to be the bearer of bad news but this is often a symptom of a cracked head. Interesting you had issues but oil was not over full or milky when first checked (on the water)

    guess there are a...
  24. Replies
    3
    Views
    346

    2015 VXR is nano 1.... common factor is not the...

    2015 VXR is nano 1.... common factor is not the material of construction...

    https://watercraftjournal.com/the-hornets-nest-2015-yamaha-vxr-waverunner/
  25. Thread: 98 GS pump seal?

    by HDAV
    Replies
    9
    Views
    624

    Thanks is it a thin bead around the mating...

    Thanks is it a thin bead around the mating surface all that is required?
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4