Search

Type: Posts; User: steve45

Page 1 of 8 1 2 3 4

Search: Search took 0.04 seconds.

  1. Replies
    79
    Views
    17,423

    Have you sealed it with 3m 5200?

    Have you sealed it with 3m 5200?
  2. Replies
    79
    Views
    17,423

    I've never flipped mine, and don't think it's...

    I've never flipped mine, and don't think it's possible in smooth water, except while idling with some klutzes aboard. However, the -15F is equipped with a vehicle down sensor.
  3. Replies
    6
    Views
    282

    While you're at it, consider replacing the...

    While you're at it, consider replacing the driveshaft holder & bearing. Rhaas has one that's made of polyurethane.
  4. Well, the grips are not 'keyed', exactly, they...

    Well, the grips are not 'keyed', exactly, they are notched.
  5. Replies
    13
    Views
    992

    That's sweet! 6 tires! Wonder how fast those...

    That's sweet! 6 tires! Wonder how fast those front 'Skis run.
  6. Replies
    79
    Views
    17,423

    I like that! It will work well when I put a pair...

    I like that! It will work well when I put a pair of these in my Yamaha Exciter boat!

    The problem I see is water ingestion if you flip the 'Ski.
  7. Replies
    13
    Views
    495

    Thanks, but I've got a service manual. As I...

    Thanks, but I've got a service manual. As I mentioned previously, I bought it for the engine and related parts. The hull, pump, etc. will be parted out. I do plan to ride it once or twice to make...
  8. Thread: Number 1

    by steve45
    Replies
    4
    Views
    157

    Is that how it works? OK.

    Is that how it works? OK.
  9. Do you happen to have a pickup truck? If so, you...

    Do you happen to have a pickup truck? If so, you could put the stand-ups in there.
  10. Replies
    13
    Views
    992

    I don't know that you would have to float the two...

    I don't know that you would have to float the two 'Skis in the front. If you had some slick bunk rails (TieDown Engineering Bunk GlideOns, etc.) you could probably slide the front 'Skis to the back....
  11. Replies
    13
    Views
    495

    I guess mine used to look like that at one time. ...

    I guess mine used to look like that at one time. I just bought it, but it looks like hell. It only has 61 hours on it, but it was left outside for years on a lift. It has lots of mold & mildew on...
  12. They are straight, but they are keyed on the end...

    They are straight, but they are keyed on the end to prevent rotation. They would have to be aligned properly on the bars, then the bars keyed to hold the grips in the right position, then the bars...
  13. Replies
    11
    Views
    672

    I'm an ATP, used to fly charters, but went broke...

    I'm an ATP, used to fly charters, but went broke before I could get enough hours for the airlines.

    Let me know the next time you think you'll be in the area!
  14. Thread: Number 1

    by steve45
    Replies
    4
    Views
    157

    Well, perhaps a moderator can delete this thread....

    Well, perhaps a moderator can delete this thread. Turns out the serial number of my engine isn't # 1. It says it is on the title, but today I looked at the engine and it's xxx003001.
  15. Keep in mind that I have the parts, but I have...

    Keep in mind that I have the parts, but I have NOT installed them yet. You might wait until I do it, as it's not as simple as installing grips on a bicycle.

    I'll see if I can install a set this...
  16. Replies
    16
    Views
    501

    I think you could store the ones you want and be...

    I think you could store the ones you want and be OK. You would have to flush them thoroughly before you leave, wash the whole thing thoroughly, keep everything sprayed with Fluid Film, put battery...
  17. Replies
    2
    Views
    190

    First Alert has a new one that fits in the old...

    First Alert has a new one that fits in the old containers. USCG approved, but don't know about EU approval.
    ...
  18. Replies
    1
    Views
    115

    Check the condition of the pulse line that...

    Check the condition of the pulse line that operates the fuel pump. If it's kinked or split, no fuel.
  19. You can cap the ends of the bars (as Kawasaki...

    You can cap the ends of the bars (as Kawasaki does) or cap the grips (as SeaDoo does). Just keep the water out of the bars so they don't rust internally.

    Have you seen the SeaDoo Palm Grips? The...
  20. Cap the ends to keep water out. You don't want...

    Cap the ends to keep water out. You don't want rust to form inside, causing the bar to fail at a critical time!
  21. Replies
    72,119
    Views
    3,557,689

    I saw this today. The bumper stickers just...

    I saw this today. The bumper stickers just really seem to go well together, don't you think?

    http://greenhulk.net/forums/attachment.php?attachmentid=443614&stc=1
  22. Replies
    8
    Views
    358

    Generally speaking, if it's rated for 3, it's...

    Generally speaking, if it's rated for 3, it's really pretty good with 2 aboard. If it's rated for 2, it's better with only 1 aboard.

    I haven't ridden the STX-15F (just bought one), but I've had a...
  23. Replies
    13
    Views
    495

    Wow! That looks like it just came from the...

    Wow! That looks like it just came from the showroom! Congratulations, Bucky!

    I picked mine up Saturday. It's kind of rough, but I bought it for the engine. Not worried about the cosmetics. ...
  24. Replies
    7
    Views
    440

    Start with the simplest things first, new spark...

    Start with the simplest things first, new spark plugs and trimming back the spark plug wires at the plug end. They vibrate a lot and the wires break internally, giving intermittent spark. Remove...
  25. Thread: Number 1

    by steve45
    Replies
    4
    Views
    157

    Number 1

    I picked up an STX-12F and an STX-15F over the weekend. I wanted the 15F for the engine, I want to try to install it in an Ultra 150 hull.

    I have a friend that was interested in the 12F, and also...
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4