Search

Type: Posts; User: Mr. GP1800

Page 1 of 8 1 2 3 4

Search: Search took 0.96 seconds.

  1. I had the ski out earlier this week. I was 1000...

    I had the ski out earlier this week. I was 1000 feet higher in elevation than where I usually ride. It was down 250 rpm from the last ride and probably down 3MPH. I only ran 62.9 as opposed to...
  2. Replies
    17
    Views
    827

    If you are concerned with warranty you want the...

    If you are concerned with warranty you want the 13/20 not the 13/18. The 13/18 will spin 200-300 RPM higher than the 13/20. The Maptuner with the bone stock tune with 8000 limiter or any of the...
  3. If you have nothing connected for a fuel level...

    If you have nothing connected for a fuel level sender it should work just like the oil gauge with nothing connected. Shouldnt trip any warning or low fuel messages. The 33-240 ohm fuel sender is a...
  4. I can program any black potted CDI for a high...

    I can program any black potted CDI for a high start curve.

    No issues there
  5. Replies
    6
    Views
    323

    That’s the speed limiter kicking in.

    That’s the speed limiter kicking in.
  6. Replies
    6
    Views
    269

    Ugly warning decal on seats

    I was at a dealer yesterday and noticed both the yamahas and sea doos had the same butt ugly warning decal embossed into the seats. Is this some new mandate from the USCG or something? Anyone have...
  7. View Post

    Got a chance to run mine. Iím at 580 feet elevation. Air temp was 50-70 depending on where I was. Water temp was 45-48. I ran 7650 rpm and 65 mph with a best of 65.9. Thatís with power filter...
  8. I used the same jetting as the virage tx. It’s...

    I used the same jetting as the virage tx. It’s the same setup you’re trying to build
  9. technically it is

    technically it is
  10. Replies
    8
    Views
    229

    You’ll have to drain the oil. Even after pumping...

    You’ll have to drain the oil. Even after pumping the oil out of the engine when you remove the oil pump you get a good amount of oil that dumps out in the hull
  11. Just put a little bit of 2 stroke oil down the...

    Just put a little bit of 2 stroke oil down the carbs. By the time that burns off you'll have mixed gas flowing. Or you can pull the fuel line off at the carbs and drain it out then it will prime...
  12. Replies
    174
    Views
    79,601

    threads? I bought a 1 1/2 inch pvc pipe cap and...

    threads? I bought a 1 1/2 inch pvc pipe cap and stuck it in the rubber pipe. Fits perfect. Clamp it down and it’s good to go.
  13. Replies
    5
    Views
    162

    1200 cranks have the pork chop shaped webs. ...

    1200 cranks have the pork chop shaped webs. 1050/900 are round.
  14. If you want more sound look at the TJ exhaust...

    If you want more sound look at the TJ exhaust mod. It costs about 2 bucks for a pvc pipe cap and that’s it.

    I have a stage 1+ tune that’s limited at 8000. I run 78 mph consistently. If you...
  15. I don’t know if that would matter much at idle...

    I don’t know if that would matter much at idle but I guess it could be the difference
  16. Replies
    19
    Views
    1,133

    I’ve tried from the TJ exhaust to a rear exit. I...

    I’ve tried from the TJ exhaust to a rear exit. I didn’t think the rear exhaust was any louder at all. Except at idle. The through hull is louder at idle because the exhaust outlet is above the...
  17. Replies
    5
    Views
    162

    It’s a shorter stroke than a 1200 crank.

    It’s a shorter stroke than a 1200 crank.
  18. Replies
    18
    Views
    1,204

    I wonder if the thicker oil made a difference

    I wonder if the thicker oil made a difference
  19. Replies
    3
    Views
    124

    WTB You can get them from McMaster Carr as well.

    You can get them from McMaster Carr as well.
  20. Replies
    7
    Views
    143

    I think it just wraps the spark plug boot

    I think it just wraps the spark plug boot
  21. By it do you mean Jack Daniels?

    By it do you mean Jack Daniels?
  22. I have them on all of my skis. It’s nice having...

    I have them on all of my skis. It’s nice having a speedo thats gps accurate
  23. it’s cheaper and nowhere near as annoying as the...

    it’s cheaper and nowhere near as annoying as the free flow kits. It actually sounds pretty good. The rear exhaust is the way to go if you really want to mod the exhaust
  24. Replies
    92
    Views
    1,949

    Sticky: The thing that people don’t seem to grasp is that...

    The thing that people don’t seem to grasp is that if we had single payer health care in this country they would no longer be paying health insurance premiums, deductibles, or copays. Their employer...
  25. I works great. Just keep it moving so you don’t...

    I works great. Just keep it moving so you don’t burn the paint with too much heat. 3m adhesive remover or a paint reducer for automotive finishes works great for getting the last bits of adhesive...
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4