Search

Type: Posts; User: allyolds68

Search: Search took 0.00 seconds.

  1. Replies
    26
    Views
    1,465

    View Post

    Iíll either buy or borrow another multimeter and report back. Mineís definitely a cheap one.
  2. Replies
    26
    Views
    1,465

    I finally got a chance to start checking a few...

    I finally got a chance to start checking a few things

    CPS 100 ohms
    air temp sensor 570 ohms
    water temp sensor 572 ohms
    stator:
    1-12 .4 ohm 8.35v
    2-11 .4 ohm 8.3v
    3-10 .6 ohm 5.3 v
    4-9 .6...
  3. Replies
    26
    Views
    1,465

    I found this link and haven’t had any luck...

    I found this link and haven’t had any luck downloading the service manuals. It says I have to log into Google drive. Which I do, but then it says someone has to approve my request. So far I haven’t...
  4. Replies
    26
    Views
    1,465

    Zzzzzzzzzzzzz

    Zzzzzzzzzzzzz
  5. Replies
    26
    Views
    1,465

    The top plug in the pic was the center one. I...

    The top plug in the pic was the center one. I put a set of the Champions in but I had too much other stuff to do today to put the ski back in the water to test it. The Champion has a different tip...
  6. Replies
    26
    Views
    1,465

    I checked a few other things out of the water...

    I checked a few other things out of the water today. First I checked the fuel pressure again. An o-ring was restricting the fuel flow. I pulled it out and the pressure immediately jump to 22 psi...
  7. Replies
    26
    Views
    1,465

    The voltage on the pump was around 0.5V. Darrin,...

    The voltage on the pump was around 0.5V. Darrin, you were correct, that the cheap HF fuel pressure gauge wasn’t depressing the schrader valve. When I removed the schrader I got 22 psi but….. the...
  8. Replies
    26
    Views
    1,465

    The motor's running so I assume the fuel pump is...

    The motor's running so I assume the fuel pump is working. I only ran it for about 5-10 seconds at a time. The RPM's come up normally but obviously it isn't under load so it doesn't mean much. In...
  9. Replies
    26
    Views
    1,465

    Fixed the fuel pressure regulator, put it all...

    Fixed the fuel pressure regulator, put it all back together, still no fuel pressure…:evil:

    I’m going to try another fuel pressure gauge first but it looks like I’ll probably be taking it apart...
  10. Replies
    26
    Views
    1,465

    sounds like an easy way to replace them. The...

    sounds like an easy way to replace them. The lower straps seem fine.
  11. Replies
    26
    Views
    1,465

    Does anyone have a spare one of these for sale? ...

    Does anyone have a spare one of these for sale? This one isn't doing much of anything anymore and I'd prefer not to have the tank jumping around
  12. Replies
    26
    Views
    1,465

    Yes the “captive” t-nut was no longer captive....

    Yes the “captive” t-nut was no longer captive. (Just spun)

    The reason I say someone had been in there before was because there was a nylock nut on it, and it was the handlebar stop one that was...
  13. Replies
    26
    Views
    1,465

    So the guy I bought this MSX from clearly lied. ...

    So the guy I bought this MSX from clearly lied. I threw it in the water and it barely got over 3000 rpm’s. (He told me it ran fine until he stopped using it three or four years ago) So I pulled it...
  14. Replies
    26
    Views
    1,465

    Those are excellent writes up on the fuel...

    Those are excellent writes up on the fuel pressure regulator reinforcement. Before I run it on the water I’ll make sure that is repaired as well as checking the hull bearing. It will be a good...
  15. Replies
    26
    Views
    1,465

    2004 MSX 140 HO post purchase questions

    First of all, thank you all for the wealth of knowledge here. This is my first post but I'm a long time lurker.

    I've been running three (now 2, sold one) SLT780's for three years now. I upgraded...
Results 1 to 15 of 15