Search

Type: Posts; User: kornchief313

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. OK! So took it to a mechanic and the issue was...

    OK!

    So took it to a mechanic and the issue was the supercharger rod was snapped :smt119

    $3.5K to get it fixed which is 50% of the value of the ski :facepalm:

    I will get it replaced and sell...
  2. Ill perform that test Sean!

    Ill perform that test Sean!
  3. Supercharger belt is okay and firmly tight. If...

    Supercharger belt is okay and firmly tight.

    If the supercharger rod was snapped inside the supercharger, would that cause no boost and all the symptoms described above?

    One would assume that...
  4. 2009 Ultra 260x idle ok, restricts at 3k for wot then stalls once throttle released

    Hi guys,

    Hoping to be pointed in the right direction to isolate the issue a bit and pin point what is happening here. I am sure someone has had this issue occur at some stage for their ski.

    On...
  5. I am having the same issues with my 260x. It...

    I am having the same issues with my 260x.

    It wont show any boost when testing on land like it used to but the belt and pully is spinning.

    From the information in this thread, I am starting to...
  6. Replies
    7
    Views
    2,794

    2009 Kawasaki Ultra 260x Stiff Steering

    Hi guys,

    My Jet ski is quite stiff to turn the handlebars both when going and also when stopped. Almost like there is no grease on the steering shaft.

    I have pulled the handlebars to bits and...
  7. 2009 Kawasaki Ultra 260x Stiff Steering

    Hi guys,

    My Jet ski is quite stiff to turn the handlebars both when going and also when stopped. Almost like there is no grease on the steering shaft.

    I have pulled the handlebars to bits and...
  8. First to come off was the engine side that is...

    First to come off was the engine side that is circled in the following image

    406416

    The second to come off and flood the hull was the red circle on the right of the above image.

    The two...
  9. Ok, an update for those with a similar issue who...

    Ok, an update for those with a similar issue who are looking for an answer.

    It turns out that the joiner between the end of the exhaust and the waterbox was not done up properly and had loose...
  10. Thanks nicjak

    Thanks nicjak
  11. Haven't cleaned injectors. Will sort that out....

    Haven't cleaned injectors. Will sort that out. Thx!

    Was wondering if you can use injector cleaner like you do for your car?

    404367
  12. Any thoughts on why it would be surging nicjak?

    Any thoughts on why it would be surging nicjak?
  13. Test results as follows: Test 1 404344 ...

    Test results as follows:

    Test 1
    404344

    Test 2
    404345

    Test 3
    404346
  14. Just to clarify the test. Remove fuel hose....

    Just to clarify the test.

    Remove fuel hose.
    Insert key and start ignition which will produce fuel.
    Then hold down start button for 3 seconds which will produce fuel.
    Measure all the fuel which...
  15. The fuel flow test has been interesting. I...

    The fuel flow test has been interesting.

    I removed the fuel cap first and then removed the fuel hose that was attached to the fuel rail.

    404270

    A bit of fuel dribbled out due to gravity so...
  16. I will complete that test and provide results in...

    I will complete that test and provide results in the next 24-48hrs.

    I cant seem to find the fuel filter anywhere in service manual?

    Do you know where it is located at all?

    404238

    Thx...
  17. Ok, I have an update after fiddling with it...

    Ok, I have an update after fiddling with it today.

    I decided to have a look inside the inlet for the intercooler with a camera scope, looking for the black coating from the supercharger rotors....
  18. Replaced fuel pump only i believe. I will mention...

    Replaced fuel pump only i believe. I will mention your suggestions MWHC and provide an update to you.

    I knew i forgot to mention something. Compression test was 150 in each cylinder from memory....
  19. 2009 Kawasaki Ultra 260X surging and no top end

    Hi everyone,

    I have a 2009 Kawasaki Ultra 260X which is baffling my Mechanic and myself the past 2 months so I am hoping for some input as to what it could be and see if anyone has seen a similar...
  20. 2009 Kawasaki Ultra 260X exhaust smoke

    Hi,

    I am a little concerned with smoke from the exhaust and thought I would ask to see if you had any idea if its normal or not.
    Thinking its steam.

    The oil and oil filter has been changed....
  21. Replies
    3
    Views
    1,456

    Once it has died again, are you able to get it...

    Once it has died again, are you able to get it going again?
    If yes, what are you exactly doing to get it going again?

    Explain in detail as to what you mean by "fiddling around with the key"?
  22. Not sure what the go was but after flushing it...

    Not sure what the go was but after flushing it again today there was sufficient water coming out of the pump/impellar area as well as the exhaust. There was still no water coming out of the pisser...
  23. Yes it has me baffled as well! There was no...

    Yes it has me baffled as well!

    There was no sealant used on the exhaust gaskets so that should eliminate the sealant part.

    I want to remove the whole exhaust down to the header gasket to check...
  24. Thankyou for your information. I will review it...

    Thankyou for your information. I will review it all and post back on the outcome.

    I am sure that your info will also be useful for others that have similar issues as when I was researching...
  25. Appreciate your feedback. The problem is that...

    Appreciate your feedback.

    The problem is that there is no water coming out of pisser hose and no where near enough water coming out the back of the jet ski when flushing compared to when I first...
Results 1 to 25 of 28
Page 1 of 2 1 2