Search

Type: Posts; User: K447

Search: Search took 0.11 seconds.

  1. Sticky: Ohm test the fuel sender after disconnecting the...

    Ohm test the fuel sender after disconnecting the wires from the electrical box.

    If the ohm reading is below 300 ohms (approximately) then the fuel sender fuse is good.

    An ohm meter reading...
  2. Sticky: Good job! =D> It is good to have the repair...

    Good job! =D> It is good to have the repair process so nicely documented.

    As far as I know, these fuel sender fuses don't fail very often.

    Your repair method with the external fuse holder...
  3. Sticky: What Amp rating external fuse did you use? A...

    What Amp rating external fuse did you use?

    A minor problem we have seen with the 1/4 Amp fuse (located inside the electrical box) for the MFD display is that the thin wire inside the fuse tends...
  4. Sticky: MFD display always shows Low Fuel - Sinking fuel float or blown sender fuse?

    The same type of fuel level sender was used in almost all 1996-2004 Polaris carburetor models, and I think also in a few 1995 models. Differences between the various senders were mainly in the length...
  5. Sticky: Repairing the fuse inside the magnetic float type fuel senders, carb models 1995-2004

    Could you post some clear photos of the repair and changes you made?

    The repair you describe sounds reasonable. What Amp rating is your replacement fuse?

    I have not seen any reports of Polaris...
Results 1 to 5 of 5