Search

Page 1 of 5 1 2 3 4

Search: Search took 1.00 seconds.

  1. Replies
    4
    Views
    93

    Seal it with sealant. Clear silicone is what I...

    Seal it with sealant. Clear silicone is what I use.
  2. Replies
    5
    Views
    1,556

    Take the rave caps off & see what rpm it gets.

    Take the rave caps off & see what rpm it gets.
  3. Replies
    12
    Views
    388

    No such thing as over oiling. Adjust the pump...

    No such thing as over oiling. Adjust the pump properly & run a good oil not cheap stuff.
  4. Replies
    8
    Views
    211

    Clean & rebuild carb & replace any grey fuel...

    Clean & rebuild carb & replace any grey fuel lines that have the name "Tempo" on them.
  5. Replies
    5
    Views
    213

    The biggest problem is NOBODY want's to or knowns...

    The biggest problem is NOBODY want's to or knowns how to work on them.

    I work on skis for a living & I dont recommend anything DI. Huge $$$$ pit.
  6. Replies
    1
    Views
    104

    You need to open the "rear hatch" & start motor &...

    You need to open the "rear hatch" & start motor & look for any exhaust leaks.

    Exhaust leaks will cause fouling plugs because the engine needs fresh air to run & any leaks will cause running...
  7. Replies
    7
    Views
    2,879

    The point where the fuel is injected makes the...

    The point where the fuel is injected makes the difference. Yamaha injectors are in the air intake area so it can be premixed.

    However Seadoo RFI & DI or Kawasaki DI's CAN NOT be premixed due to...
  8. Replies
    5
    Views
    212

    Replace starter solenoid withe OEM .

    Replace starter solenoid withe OEM .
  9. Replies
    9
    Views
    363

    Great ski till you have to work on it....the...

    Great ski till you have to work on it....the whole top has to come off which can be very espensive when it comes time to work on it....rusted & corroaded fasteners make the bill go higher.

    IMO...
  10. Deltran battery tender

    Deltran battery tender
  11. Replies
    1
    Views
    218

    Long story short No 99 GSX is either a 951...

    Long story short No

    99 GSX is either a 951 or fuel inj 800 neither will work.
  12. Replies
    9
    Views
    1,763

    You cant use a (66E servo 800) in place of a (66V...

    You cant use a (66E servo 800) in place of a (66V 1200 servo) & vice versa.

    Servo dont work right replace it with the right one.
  13. X 2 check reeds

    X 2

    check reeds
  14. Replies
    24
    Views
    839

    Tygon fuel line from any weed wacker repair shop.

    Tygon fuel line from any weed wacker repair shop.
  15. Crank & balance shaft timed wrong.

    Crank & balance shaft timed wrong.
  16. Replies
    6
    Views
    311

    Thru hull carrier bearing is leaking more than...

    Thru hull carrier bearing is leaking more than likely.
  17. Replies
    5
    Views
    1,178

    Doubtful at best.....

    Doubtful at best.....
  18. Replies
    24
    Views
    1,377

    True dat !!

    True dat !!
  19. Replies
    24
    Views
    1,377

    Really ??? Its a filter that you can clean...You...

    Really ??? Its a filter that you can clean...You cant clean a Yamaha fuel filter. Been working on skis for close to 30 years & have yet to come across a better fuel filter. Heck Seadoo stole the...
  20. So much drama.:roll:

    So much drama.:roll:
  21. Replies
    10
    Views
    750

    There is a foam seal or just run a ring of clear...

    There is a foam seal or just run a ring of clear silicone where the wear ring seals against plate,install pump let sit for 24 hours to cure.
  22. Buy a small shop vac & suck it out.

    Buy a small shop vac & suck it out.
  23. Replies
    5
    Views
    321

    You cant run a 3D without a pump. The loud...

    You cant run a 3D without a pump.

    The loud "whooping" noise is the driveshaft smacking the pump support because there is no support when the pump is out.

    You need to remove the clip for the...
  24. As usual you guys tend to way over think things. ...

    As usual you guys tend to way over think things. It will be fine just advance the oil pump & call it a day.

    I run a modded 951 at 80:1 with Amsoil 100:1 oil !!!
  25. Replies
    7
    Views
    375

    Nope

    Nope
Results 1 to 25 of 118
Page 1 of 5 1 2 3 4