Search

Page 1 of 16 1 2 3 4

Search: Search took 1.00 seconds.

  1. Replies
    27
    Views
    4,185

    sorry to be repeating the sale old advice after 5...

    sorry to be repeating the sale old advice after 5 years, but any ski sunk in saltwater is going to require a complete go over of every single electric connector and bolt on the ski. any salt that was...
  2. Replies
    84,535
    Views
    6,160,483

    They should expect a cease and desist order early...

    They should expect a cease and desist order early next week. In one of his many TV interviews The gun toting attorney said he is a bit pissed about the unauthorized use of his image for commercial...
  3. Replies
    4
    Views
    179

    yeah, find a new shop that isn't trying to make...

    yeah, find a new shop that isn't trying to make the rent. 120 is low, but serviceable if all four were at or close to that number

    btw the exhaust manifold and system is the only thing directly...
  4. you can typically form the correct size for...

    you can typically form the correct size for things like this by using some 1 inch PVC and a little heat on the billet part to melt the plastic into the desired shape. You can try that if your...
  5. Wow $1100 for a plastic bag infestation? WTF ...

    Wow $1100 for a plastic bag infestation?

    WTF

    was it a full roll of 99 gallon contractor grade bags?

    Iím raising my labor rate to $300 an hour next season!
  6. Replies
    15
    Views
    529

    voltage over 14.4 is indicative of a bad voltage...

    voltage over 14.4 is indicative of a bad voltage regulator and that can spike the emm and cause all sorts of problems

    connectors are difficult to source, I'd not worry about it too much

    I...
  7. Replies
    3
    Views
    116

    welcome aboard GH. The message sure sounds like...

    welcome aboard GH. The message sure sounds like the maintenance timer, especially since as you say the ski is running well. Consider it a reminder to drink a bottle of water or to reapply sunscreen...
  8. Vegas Casino President Killed in Jetski Accident

    Yet another high profile PWC accident

    He was hit by a 77 year old man driving a 27 foot boat

    Most of the reports called the jetski a "watercraft" for some reason, this one didn't:...
  9. Replies
    15
    Views
    529

    water flow to emm may be restricted. Careful...

    water flow to emm may be restricted. Careful removing the hoses, the connections may be brittle, warm hoses with hair dryer first and take your time
    CPS connection may be hanging on by a thread,...
  10. Replies
    34
    Views
    1,018

    check the fuel pressure, likely the pump is shot...

    check the fuel pressure, likely the pump is shot

    I've done that dance a few times.

    Doubtful?

    throw a TEASPOON of gas down each plughole and watch is sputter and stall.
  11. remove #5, that is where the cooling water is...

    remove #5, that is where the cooling water is tapped off the pump output

    http://greenhulk.net/forums/attachment.php?attachmentid=463931&stc=1
  12. this is looking like another case of a clogged...

    this is looking like another case of a clogged jetport water outlet screen. you can't feed these things weeds and muck too often, they don't play well.

    pull the pump, you'll find the water inlet...
  13. Replies
    5
    Views
    448

    sinkage recovery typical includes disconnecting...

    sinkage recovery typical includes disconnecting each reasonably accessible electrical joint, blow drying with compressed air and regreasing. you got lucky
  14. Thread: Water in Cyls

    by nmpeter
    Replies
    1
    Views
    292

    welcome aboard why waste time dicking with...

    welcome aboard

    why waste time dicking with this engine?..it's going to need to come out anyway if water sat in it for any length of time

    don't trust a thing the PO told you, the 12v low message...
  15. Replies
    22
    Views
    1,653

    always better to start a new thread for a new...

    always better to start a new thread for a new issue, but I'll indulge you here.

    112 seems a bit low to me. but even across all three jugs is good, very

    I'd get a known good compression gauge...
  16. Replies
    84,535
    Views
    6,160,483

    hahahah them seemed to forget to talk to the cops...

    hahahah them seemed to forget to talk to the cops about that move first.

    most domestic calls in our great state involve a firearm or two, cause even grandma packs a .357 in her glovebox and when...
  17. Sticky: that's exactly on Target :bonus content:...

    that's exactly on Target

    :bonus content:
    -----------------

    as to your newly minted callsign......

    I actually was issued one, even though I never served in the Military, back in 1986, I was...
  18. Sticky: that would mean you're simply an actor, like...

    that would mean you're simply an actor, like somebody who we won't mention.


    as when it comes to the competent repair of digital electronic devices in hostile territory, there are simply no...
  19. Replies
    12
    Views
    1,028

    depends on the size

    depends on the size
  20. Replies
    22
    Views
    1,653

    follow-ups are always appreciated by all who come...

    follow-ups are always appreciated by all who come across this stuff in the future needing to know how to solve the problem and it sure keeps us from having to repeat methods and procedures too many...
  21. Replies
    84,535
    Views
    6,160,483

    AND FROM THE OTHER SIDE OF THE AISLE SO TO...

    AND FROM THE OTHER SIDE OF THE AISLE SO TO SPEAK.......

    http://greenhulk.net/forums/attachment.php?attachmentid=462838&stc=1
  22. given the costs involved, if you bought this boat...

    given the costs involved, if you bought this boat without service records, its likely way overdo for a blower rebuld, a pump check and some new driveline seals/bellows at the minimum.

    Seadoo...
  23. Replies
    70
    Views
    2,447

    send it to Lakeside without even blinking if...

    send it to Lakeside without even blinking

    if it means anything, I'm in this business for 12 years and lakeside is my goto for anything emm, since my last goto got out of the business about 5+...
  24. Replies
    22
    Views
    1,653

    you're wasting your time and effort. Without 13.5...

    you're wasting your time and effort. Without 13.5 v at the battery when the engine is running the problem is most likely the emm. you can check the stator, but problems there typically result in a no...
  25. not all all, the subliminal message is that the...

    not all all, the subliminal message is that the "friend" should be at least paying for the solenoid, if not the rope removal labor.

    Likely the same person who keeps trying to start a car while the...
Results 1 to 25 of 400
Page 1 of 16 1 2 3 4