Search

Type: Posts; User: Screeb

Search: Search took 0.00 seconds.

  1. If you need help call SBT (Short Block...

    If you need help call SBT (Short Block Technologies) (877) 330-0231 and ask for a technician hours are 8 am to 5 pm they are located in Clearwater, FL... anytime I need help I always call them
  2. The problem I had that the idle screw was turned...

    The problem I had that the idle screw was turned up too much so it was pouring out too much water and the water pressure was so much and cannot go back up once I turned down the idle screw it was fine
  3. If you have questions call SBT (Short Block...

    If you have questions call SBT (Short Block Technologies) (877) 330-0231 and ask for a technician... Monday-Friday 8:00AM to 5:00PM
  4. So if you look inside the jet pump you are going...

    So if you look inside the jet pump you are going to see a tiny hole. Follow that hose to the exhaust manifold disconnect the hose from the exhaust manifold and blow air through the hose. To make sure...
  5. I would check your jet pump vane and make sure...

    I would check your jet pump vane and make sure that there not damage. and blow out your water in line with air... The reason why, the water might be moving to slow and heating up to much and melting...
  6. Is that a rubber hose or a medal hose??

    Is that a rubber hose or a medal hose??
  7. Replies
    2
    Views
    260

    It could be the reed valves. The reed valves...

    It could be the reed valves. The reed valves could be putting in to much air which is making it starve for fuel. If you have a feeler gauge anything under .008 is good anything above you have to...
  8. Replies
    2
    Views
    260

    What is the compression??? On a 96 Waverunner 3...

    What is the compression??? On a 96 Waverunner 3 650 the compression should be 120-150.. I have the same jet ski and that was my problem
Results 1 to 8 of 8