Search

Type: Posts; User: zoomjay

Page 1 of 5 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    0
    Views
    84

    3D start stop switch removal/testing

    I have an 05 3d which is having an issue with the start/stop button (or something related). I recently replaced the DESS post to solve one problem... and then this started. I can place the key on...
  2. Replies
    7
    Views
    181

    I did figure this out. Turns out that the plug...

    I did figure this out. Turns out that the plug boot for the PTO plug had gone bad which was causing it to miss badly on that cylinder. New plug boot... all good to go now.
  3. Replies
    2
    Views
    103

    help me understand the mpem... how could that be...

    help me understand the mpem... how could that be causing this... and/or is this the typical intermittent computer error?
  4. Replies
    7
    Views
    181

    have done that... no exhaust leaks. In fact, I...

    have done that... no exhaust leaks. In fact, I have taken to testing it in the water without the seat to see what it is doing.
  5. Replies
    7
    Views
    181

    04 gti RFI SE - still having issues

    I am having ongoing running issues with this ski. This is the situation:

    a) Motor is new/rebuilt by a shop in NJ.
    b) It does start and run although idles rough... and will not rev when on the...
  6. Replies
    2
    Views
    103

    05 GTX SC - code P1200

    I have an 05 GTX SC showing a code P1200: blow by valve short or open circuit. This is what I have done thus far..... First, recently I replaced the oil pressure sensor on the front of the valve. ...
  7. Replies
    2
    Views
    110

    fuel pressure gauge for 04 GTi LE RFI

    I am still having issues with this 04 GTi. Need to check the pressure in the fuel line. I do have a "standard" fuel pressure gauge although the shrader valve on the ski is a bit too large to fit it...
  8. Replies
    8
    Views
    411

    Ok... I understand. I can do all except zero out...

    Ok... I understand. I can do all except zero out the tps.... which I cannot find in the forum. Any help or guidance is appreciated.
  9. Replies
    8
    Views
    411

    No maintenance light or other errors

    No maintenance light or other errors
  10. Replies
    8
    Views
    411

    I do not see any responses... bigger question: ...

    I do not see any responses... bigger question: if not the fuel injectors.... assuming all else is right, what else could it be? I do not think that the throttle body could be causing this (it...
  11. Replies
    8
    Views
    411

    2004 GTi RFI LE - idle and other issue

    I have an 04 GTi RFI which is going some odd stuff. The motor is new (just rebuilt by a shop in New Jersey)... timed correctly and is all good. Motor starts and runs although idles rough. Once...
  12. Replies
    0
    Views
    101

    05 GTX Supercharged - shaft issues?

    I have an 05 GTX 4tec supercharged that I am trying to finish and get moved out of my garage. Took it out for a water test and it ran great... like really great until it made an odd sound from the...
  13. Replies
    2
    Views
    174

    got it.. thank you

    got it.. thank you
  14. Replies
    2
    Views
    174

    ideas on new ECM for 2004 GTX 4tec

    It would appear that I need a new ECM for my 2004 Sea Doo 4tec. Number on the old one is 664564. I do not recognize another part number on it. Issue with it is that it is not turning off the power...
  15. Replies
    11
    Views
    441

    Let me clarify what I think is happening here. ...

    Let me clarify what I think is happening here. The ECM is the part which is on top of the air intake and it is tied to the DESS key - thus, they go in pairs - correct?

    I have an 05 GTX which I...
  16. Replies
    5
    Views
    291

    well, it probably wasn't me forcing it... it was...

    well, it probably wasn't me forcing it... it was the bolting down after that did it. I can see in the bearing at the rear where I force the shaft back about 1/2 inch. I Have now pulled the pump and...
  17. Replies
    5
    Views
    291

    05 3d - getting the shaft

    I have an 05 3D that I am working on. As I was putting the pump back on it (after inspection and new wear ring) and I was a bit too physical with it and believe I have damaged the intermediate/drive...
  18. Replies
    11
    Views
    441

    Okay, got it. While I am digging into this...

    Okay, got it. While I am digging into this thing... are there any other obvious things I need to look for? When I connect the batter I hear something around the gas tank click like it is going on...
  19. Replies
    11
    Views
    441

    am guessing EMM means Engine Management Module......

    am guessing EMM means Engine Management Module... aka the brains behind the operation... correct? Where is the regulator located? I disconnected the battery yesterday and should be able to...
  20. Replies
    11
    Views
    441

    electrical issue: 2004 GTX Supercharged

    I have a 2004 GTX Supercharged that is having an electrical issue. Specifically, when it sits for a week or so it will drain the battery dead, dead, dead. Thus, it has some sort of draw going on...
  21. Thread: RXT vs RXP 300

    by zoomjay
    Replies
    47
    Views
    14,613

    Other thing you need to consider is what else you...

    Other thing you need to consider is what else you might do with the ski. In other words, will you ever try to tow a skier or a tube? If so, then you HAVE to have a 3-seater (as least in VA). You...
  22. Replies
    2
    Views
    328

    2005 stx 12f head - same as 15f ?

    I am looking online and it appears to me that the head and cover from an 05 stx 12f is the same as the 15f.... is this correct?

    Thanks
  23. Black stuff inside an 05 720 motor?? Paint?

    I just opened up a 2005 720 motor from a GTi that experienced a lower rod bearing failure. I noticed (as the photo shows) that the one side with the bad rod lost all of it's "black coating" from the...
  24. Replies
    2
    Views
    278

    used motor question

    I have a 4 stroke motor from an 2005 STX 12F. Motor is locked up although looks to be in good shape overall (no water penetration or thrown rods). I suspect oil pump failure although am not sure. ...
  25. Replies
    3
    Views
    553

    Agree with what the others say... you might also...

    Agree with what the others say... you might also look at the fuel lines. How old is your ski? Do you still have the original gray fuel lines in it? If so, those do need to be changed.
Results 1 to 25 of 101
Page 1 of 5 1 2 3 4