Search

Type: Posts; User: steve45

Page 1 of 8 1 2 3 4

Search: Search took 0.05 seconds.

  1. Replies
    9
    Views
    225

    Kids!

    Kids!
  2. I haven't tried them, but I came close. Found a...

    I haven't tried them, but I came close. Found a used one in good condition and bought it for about $400.

    If yours has been sitting for more than a day or two with moisture in it, alcohol probably...
  3. Replies
    2
    Views
    112

    I, too, have purchased thousands of dollars in...

    I, too, have purchased thousands of dollars in parts from a number of suppliers. I've only received one wrong part, Yamaha mis-labelled a a bolt. In fact, I've gotten several incorrect Yamaha parts...
  4. I'm glad you're not asking for much. :roll: As...

    I'm glad you're not asking for much. :roll:

    As mentioned, the Kawasaki STX-15F will come close. Perhaps it will hit 70 with an aftermarket impeller. It's an old hull design that will ride a bit...
  5. Replies
    5
    Views
    168

    The Yamaha and Kawasaki lanyard clips look very...

    The Yamaha and Kawasaki lanyard clips look very similar, but are different thicknesses. You can pick up a generic lanyard at most any marine/power sports dealer that will fit Yamaha, Kawasaki, and...
  6. Hell, that's only 21 years old! Might as well...

    Hell, that's only 21 years old! Might as well blame the carbs for neglect!
  7. Replies
    4
    Views
    89

    You can buy separate fuel pumps I if you don't...

    You can buy separate fuel pumps I if you don't like the factory model.
  8. Replies
    3
    Views
    91

    Are you losing boost when this happens? Water...

    Are you losing boost when this happens? Water getting sprayed on the belt could cause slippage.
  9. Thread: Fatality

    by steve45
    Replies
    3
    Views
    180

    Fatality

    Two of my co-workers tried to assist a man that died as a result of a PWC accident Saturday, at Lake E.V. Spence in Robert Lee, Texas.

    So far there have been no reports about the accident in the...
  10. Replies
    4
    Views
    127

    Oh, I've owned 3 Waverunners and still have my...

    Oh, I've owned 3 Waverunners and still have my Yamaha boat! I find them to generally be ridiculously hard to work on, hence I own mostly Kawasaki.

    The best 'Ski is the one that runs!
  11. Replies
    4
    Views
    89

    I would assume that you cleaned the internal...

    I would assume that you cleaned the internal filters, correct? New O-rings on the fuel rails and needle valve seats? Pop-off about 15 PSI? Chokes installed? Factory flame arrestor?
  12. I've owned both, and had both apart, but I...

    I've owned both, and had both apart, but I honestly don't remember. Does the motor work, or at least try to work? I've had the magnets come loose in one motor. Bad brushes in another (4 brushes, 2...
  13. Replies
    4
    Views
    127

    Got To Ride A 2016 Yamaha FX Cruiser SVHO

    A friend of mine picked up a 2016 Yamaha FX Cruiser SVHO recently that only had about 10 hours on it. I rode it about 30 minutes last weekend.

    It really seemed to accelerate and handle a lot like...
  14. Replies
    72
    Views
    4,902

    Oh, good! Something else to break!

    Oh, good! Something else to break!
  15. Replies
    3
    Views
    135

    I think that for best results, you need to do it...

    I think that for best results, you need to do it when it's warm. Stretch the material before stapling. I think mine was a little cool, allowing small wrinkles to form when it got hot.
  16. Replies
    3
    Views
    135

    Have you read this? ...

    Have you read this? http://greenhulk.net/forums/showthread.php?t=8572

    I just replaced a seat cover on a seat that was like that. It had duct tape on the tear and it did show through a little...
  17. Replies
    4
    Views
    122

    Could be a problem with fuel tank venting.

    Could be a problem with fuel tank venting.
  18. Replies
    9
    Views
    225

    Ha! I bet these millennials don't have a Clue! ...

    Ha! I bet these millennials don't have a Clue! :-k
  19. Replies
    1
    Views
    53

    Call Carl at Island Racing.

    Call Carl at Island Racing.
  20. Replies
    9
    Views
    225

    Possibly in the garage with a candlestick holder.

    Possibly in the garage with a candlestick holder.
  21. You may have water or other trash in the fuel...

    You may have water or other trash in the fuel tank that is being pickup up when you spin it.
  22. Thread: 97 stx 1100

    by steve45
    Replies
    3
    Views
    82

    Fuel filter? Fuel pump?

    Fuel filter? Fuel pump?
  23. Thread: 1997 1100 stx

    by steve45
    Replies
    6
    Views
    141

    Oh, you're right! I was thinking of the ZXi. ...

    Oh, you're right! I was thinking of the ZXi. The STX did have a digital display. Sorry 'bout that.
  24. If you torqued the M8 bolts, I'd just guess on...

    If you torqued the M8 bolts, I'd just guess on the M6 bolts. I wouldn't take it apart and re-do it.

    I wouldn't start the engine out of the 'Ski. It would be very loud, and it may move around a...
  25. Thread: 1997 1100 stx

    by steve45
    Replies
    6
    Views
    141

    Does it have an hourmeter?

    Does it have an hourmeter?
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4