Search

Search: Search took 1.00 seconds.

  1. Replies
    2
    Views
    918

    http://www.osdparts.com/index.php?main_page=produc...

    http://www.osdparts.com/index.php?main_page=product_free_shipping_info&cPath=4&products_id=13

    http://www.ebay.com/itm/280943393846?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649
    ...
  2. Replies
    14
    Views
    2,863

    There is a gear driven round metal rotary valve...

    There is a gear driven round metal rotary valve that sits right behind the carb manifold cover..

    Remove the carbs and round manifold cover - inspect for damage
  3. Replies
    12
    Views
    9,604

    You have already replaced the whole charging...

    You have already replaced the whole charging system..

    Do a battery voltage test while running your engine at 3500 rpm - the battery voltage should be around 13.5 volts..

    Do a resistance test...
  4. Replies
    24
    Views
    3,850

    no - the tests are non running.. You are going...

    no - the tests are non running.. You are going to do a resistance test for both tests - the test to ground you want - no reading , no countinunty to ground, thus showing an open
  5. Replies
    4
    Views
    907

    there is a spring chart that lists the pop-off...

    there is a spring chart that lists the pop-off pressure for different spring and N/S sizes - this will get you near the ballpark of spec..
    The size is of the needle seat is stamped on it..
  6. Replies
    4
    Views
    907

    pulling the choke richens the mixture and it also...

    pulling the choke richens the mixture and it also increases the carb vacuum - you need to check your pop-off pressure, your jetting, screw settings and check your fuel filters again.

    Most Mikuni...
  7. Replies
    6
    Views
    991

    black to black/yellow - magnet "on" switch ...

    black to black/yellow - magnet "on" switch

    black to white/gray - DESS chip reader
  8. Replies
    6
    Views
    991

    can you provide a little more insite into your...

    can you provide a little more insite into your problem??
  9. to test the stator - unplug the yellow wires...

    to test the stator - unplug the yellow wires going to the rectifier - test for countinuity to engine ground on the engine side of the wiring - should show an open circuit or not grounded..
    Now test...
Results 1 to 9 of 9