Search

Type: Posts; User: K447

Page 1 of 8 1 2 3 4

Search: Search took 0.29 seconds.

  1. Thread: solenoid

    by K447
    Replies
    2
    Views
    51

    There is a Seadoo part number that is a drop in...

    There is a Seadoo part number that is a drop in upgrade replacement solenoid.

    Click below, search in there for solenoid

    http://polarispwcknowledge.shorturl.com/first-things-to-do
  2. Sticky: You are using ohm measurement mode on the meter,...

    You are using ohm measurement mode on the meter, or circuit continuity mode? They are different measurements, with different units.

    On most digital meters continuity mode the meter beeps when...
  3. Replies
    11
    Views
    217

    Check whether all the LR module functions...

    Check whether all the LR module functions actually work.

    Confirm battery charging voltage is correct when engine is running.

    Confirm bilge pump voltage on Orange wire group. Should provide full...
  4. HS?

    HS?
  5. I use a stainless steel snap hook from Wichard...

    I use a stainless steel snap hook from Wichard (#2482, 4 inch) that is just large enough to fit around the chubby Yamaha bow eye.

    Works well, easy to handle even with wet hands.
  6. Replies
    39
    Views
    8,197

    Sticky: I will point out that Lakeside Tech worked a lot...

    I will point out that Lakeside Tech worked a lot of hours and made significant investments to understand and develop repair methods for the Ficht EMM. Specialized methods, hours of experimentation...
  7. Replies
    3
    Views
    86

    View Post

    Replace the battery. Doesn’t matter whether it is causing the Lo warning.

    A watercraft is not something you want to be trusting a marginal battery in. If the battery completely fails while you are...
  8. Thread: Weber MPE-750

    by K447
    Replies
    3
    Views
    81

    Did you try contacting Williams directly?

    Did you try contacting Williams directly?
  9. Replies
    23
    Views
    878

    Thank you for explaining that. Your...

    Thank you for explaining that.

    Your configuration is unusual, using the Aux battery to boost start a weakened main battery, rather than saving the main battery from being drained by connecting...
  10. Sticky: As long as that thin red wire is getting full...

    As long as that thin red wire is getting full battery voltage, doesn’t matter which end of the heavy red cable it is getting it from.

    Up to you to confirm the voltage going into the electrical...
  11. Replies
    23
    Views
    878

    Which 2 side are the aux battery loads connected...

    Which 2 side are the aux battery loads connected to?
  12. Sticky: yes, 9volts to stator Brown wire Dig into the...

    yes, 9volts to stator Brown wire

    Dig into the heavy electrical. The MFD should never self-reboot. Not while cranking. Not while running.

    Something is resistive or failing in the primary...
  13. Replies
    2
    Views
    55

    WTB - Parts I do not have any. They called sponsons. Any...

    I do not have any. They called sponsons.

    Any year Genesis would fit, I think.
  14. Replies
    23
    Views
    878

    Thanks. How do the switch modes relate to the...

    Thanks.

    How do the switch modes relate to the wiring connections?

    Want to understand when the ACR is allowed to sense and combine/disconnect automatically.
  15. Replies
    8
    Views
    154

    That is a genuine Polaris through-hull bushing....

    That is a genuine Polaris through-hull bushing. Looks a tad short, so it may be the variant originally from a Genesis model. Just fine to use in a Virage or other model.

    OEM are no longer...
  16. Replies
    2
    Views
    50

    Search here (http://pwcmanuals.shorturl.com/). ...

    Search here.

    Read more here.


    Rings go non-etched side down.

    Did you check/adjust ring end gap before putting the rings on the pistons?
  17. Sticky: It is a sign. That something very basic is wrong...

    It is a sign. That something very basic is wrong with the battery electrical system.

    Look for problems at each end of every battery cable. Especially engine ground.

    But also where the...
  18. Replies
    23
    Views
    878

    Can you post the wiring diagram for the ACR wired...

    Can you post the wiring diagram for the ACR wired to/with with the big switch?
  19. Certainly if you are riding much over 70mph, with...

    Certainly if you are riding much over 70mph, with the stock ride plate the 2019 FX gets squirrely around 73+
  20. Replies
    5
    Views
    191

    Possible jet pump ventilation. There might be a...

    Possible jet pump ventilation. There might be a leak where the driveshaft enters the hull or at the mid-wall bearing, where there are shaft seals.

    Check the rubber driveshaft tube centered behind...
  21. Replies
    5
    Views
    77

    John also runs a good used parts web site, Rock...

    John also runs a good used parts web site, Rock County JetSki

    https://rockcountyjetski.webs.com/
  22. I wish PWC hulls were self-ventilating when the...

    I wish PWC hulls were self-ventilating when the engine is not running. There are a couple of ventilation tubes that connect the outside air to the hull interior, down low inside the hull. Those are...
  23. Replies
    4
    Views
    291

    What change did you do?

    What change did you do?
  24. Replies
    6
    Views
    277

    Did you put in so much grease that there is...

    Did you put in so much grease that there is hydraulic pressure inside the housing?

    When the grease expands with heat will it be putting pressure on the seals?
  25. Replies
    5
    Views
    77

    No fuel pump or rebuild kit?

    No fuel pump or rebuild kit?
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4