Search

Type: Posts; User: tiderider

Page 1 of 8 1 2 3 4

Search: Search took 0.05 seconds.

  1. The o-rings in the ball bearing with bellows...

    The o-rings in the ball bearing with bellows rides on that scuffed up surface that you scratched up by sanding. It maintains a seal to prevent engine oil from spilling in to your hull.. The...
  2. Replies
    3
    Views
    128

    I would sell it and stick to bicycles... Like the...

    I would sell it and stick to bicycles... Like the non gas powered type.. Maybe an electric bike would be safe as well..
  3. You just opened a can of worms. Even after being...

    You just opened a can of worms. Even after being given advice for a simple fix of removing the PTO cover...
  4. Replies
    6
    Views
    190

    I've seen some which the gear on the flywheel,...

    I've seen some which the gear on the flywheel, that the supercharger rides on is completely worn off. Removed the supercharger and feel inside for 2 full sets of gears on the flywheel. When you reach...
  5. Replies
    2
    Views
    109

    If it has the ceramic clutches/washers rebuild...

    If it has the ceramic clutches/washers rebuild the whole unit with the most up to date kit. ASAP. No, don't just replace the washers...
  6. Replies
    2
    Views
    85

    You have to pull very hard in and out till it...

    You have to pull very hard in and out till it comes off. Its just spline to splines.. it has a rubber bumper at the tip of it. Make sure you remove the c-clip from the floating support ring that...
  7. Replies
    10
    Views
    235

    How many hours have you put on your Wiseco piston...

    How many hours have you put on your Wiseco piston set up?
  8. Replies
    18
    Views
    1,353

    Is there any risk of hydro locking the engine...

    Is there any risk of hydro locking the engine with any of this condensation? I am asking as a few days back while going from 6000 rpms to Wot, I could feel the engine go from WOT back down to 5-6K...
  9. Replies
    9
    Views
    424

    With the same impeller? In the long run BOOM.....

    With the same impeller? In the long run BOOM.. 600 more RPMs due to more power and larger impeller, better top speed.
  10. Replies
    4
    Views
    234

    Or go with an ET137 and a tune for reliability....

    Or go with an ET137 and a tune for reliability. You may want to refresh the engine with a rebuild at this point..
  11. I let off 80 rounds of American eagle .44 magnum...

    I let off 80 rounds of American eagle .44 magnum bullets over the weekend at the club without a single issue.. Runs better then a seadoo?? lol..
  12. Thread: IC repair?

    by tiderider
    Replies
    3
    Views
    204

    Go fizzle or go home with the intercooler..

    Go fizzle or go home with the intercooler..
  13. Replies
    18
    Views
    596

    Do your flywheel bolts or else... I lost an...

    Do your flywheel bolts or else... I lost an engine to the flywheel bolts in the past with the ET127+4mm set up..
  14. Replies
    1
    Views
    90

    Pressure test the intercooler.. Supercharger slip...

    Pressure test the intercooler.. Supercharger slip test? Spark plugs are new? Test the ignition coils.. Verify fuel pressure.
  15. Replies
    8
    Views
    256

    It would depend on the catalogue number of your...

    It would depend on the catalogue number of your ECU. 420664946 is for the 2007 speedster 150 215hp ECU which is on Riva's list of can tune ECUs.. as an example. Boats have an issue with the ecu being...
  16. The newer OEM valves would work great. I...

    The newer OEM valves would work great.

    I typically verify that the valves do no have much side to side play when its in the valve guide. All valve stem seals get replaced. The new valves have to...
  17. Replies
    8
    Views
    190

    Fuel pump or its fuse..

    Fuel pump or its fuse..
  18. Shell Rotella T6 5W40 synthetic is doing very...

    Shell Rotella T6 5W40 synthetic is doing very well on 4 PWC this year (SC and non SC engines). I put it in all 4 stroke rotax engines. I picked up a few large pails at a great price. Works out to $5...
  19. Replies
    18
    Views
    386

    Did your fuse melt at its terminals? Or did if...

    Did your fuse melt at its terminals? Or did if blow, as in like a short circuit or overload? If it melted (Melted plastic terminals), its probably due to a loose or dirty connection when the fuse is...
  20. Replies
    11
    Views
    392

    Numerous times Seadoo water crafts come out of...

    Numerous times Seadoo water crafts come out of the factory with the engine/driveshaft needing alignment. Looks like their factory does this process with 1 eye closed.. I've seen many with either...
  21. Replies
    18
    Views
    381

    .?

    .?
  22. This thread should be moved to Sea doo open...

    This thread should be moved to Sea doo open discussion..
  23. Replies
    0
    Views
    90

    Better throttle bodies

    Over time which throttle body has been better or more reliable?
    The cable throttle body, pre 2009 or the electronic assembly, Bosch type?
  24. Isn't this thread in the wrong seadoo section.. ?...

    Isn't this thread in the wrong seadoo section.. ? There is a seadoo open discussion area for it? I've haven't heard of many people complaining about their machines being damaged by the dealer. Do the...
  25. Replies
    18
    Views
    1,675

    It is amazing. I tried it over the weekend. Go...

    It is amazing. I tried it over the weekend. Go for it!!
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4