Search

Type: Posts; User: Cstang50

Search: Search took 0.00 seconds.

  1. Replies
    34
    Views
    4,236

    i got it all back together. im ready for the...

    i got it all back together. im ready for the summer so i can take it out on the lake.
  2. Replies
    14
    Views
    3,011

    i went with pwc engines and im very impressed ...

    i went with pwc engines and im very impressed with there costumer service and prices the parts were very well packed too. I ordered a rebuilt crank shaft and had them rebuild my counter balance.
  3. Replies
    34
    Views
    4,236

    I'm suprised it ran and didn't brake the case.

    I'm suprised it ran and didn't brake the case.
  4. Replies
    34
    Views
    4,236

    well i have more then just a seal wrong ...

    well i have more then just a seal wrong

    http://i60.photobucket.com/albums/h28/Cstang50/2E44C584-CA6E-430F-A02C-39C938F8A720_zpsuq4rzrue.jpg
  5. Replies
    34
    Views
    4,236

    ok thank you...

    ok thank you...
  6. Replies
    34
    Views
    4,236

    I pulled the motor and got the flywheel puller...

    I pulled the motor and got the flywheel puller yesterday so i will start pulling it apart tonight. i hope its just the seal and the crank is still good. what is a good brand gasket kit to go with. i...
  7. Replies
    34
    Views
    4,236

    thank for the help. yeah im going to just pull...

    thank for the help. yeah im going to just pull the motor. i want to make sure i get it all sealed up good. iv been fighting with this ski all summer and about to give up. lol
  8. Replies
    34
    Views
    4,236

    I pressurized my fuel system and it holds...

    I pressurized my fuel system and it holds pressure for 10 min. I will give that a try too. I just need to fix this seal first it's leaking good and soked my stator now it don't work.
  9. Replies
    34
    Views
    4,236

    Thank you for the reply. should i pull the motor...

    Yes, that's a huge problem and you can change that seal without splitting the cases. That seal leaking can definitely cause a lean run and cause all sorts of problems.[/QUOTE]
    Thank you for the...
  10. Replies
    34
    Views
    4,236

    I pulled the carb off again and went threw it and...

    I pulled the carb off again and went threw it and this time I pulled the stator cover off and it has a lot of oil in it and the spring from the seal was stuck to the stator. I have a few questions....
  11. Replies
    34
    Views
    4,236

    ok so i took the carbs back off and cleaned them...

    ok so i took the carbs back off and cleaned them really good made sure the pop off is set to 21 on both carbs i also got a new switch to make sure it wasn't causing me any problem. i pressured the...
  12. Replies
    34
    Views
    4,236

    Yea, I even rode it with the seat off to see if I...

    Yea, I even rode it with the seat off to see if I could find a leak but i couldn't see any.
  13. Replies
    34
    Views
    4,236

    thank you for the links great info I'm going to...

    thank you for the links great info I'm going to pull the carbs off again and test them. Im going to pull the adjusters and clean them too
  14. Replies
    34
    Views
    4,236

    I had the pop off pressure set to factory setting...

    I had the pop off pressure set to factory setting and I also set the high and low speed adjusters to them too. But one thing I didn't do was pull the adjusters out and clean the passages I'm going to...
  15. Replies
    34
    Views
    4,236

    http://i60.photobucket.com/albums/h28/Cstang50/Mob...

    http://i60.photobucket.com/albums/h28/Cstang50/Mobile%20Uploads/1E0BD3D0-633C-4744-B2C9-E412FF91FA12_zpsdb8jdzi9.jpg
  16. Replies
    34
    Views
    4,236

    http://i60.photobucket.com/albums/h28/Cstang50/Mob...

    http://i60.photobucket.com/albums/h28/Cstang50/Mobile%20Uploads/16EA46A4-CB6D-42B9-BB96-6272B5ABF793_zps8qhhwl6k.jpg
  17. Replies
    34
    Views
    4,236

    I did a compression test today and it is 140-136...

    I did a compression test today and it is 140-136 so I think I'm good there. I pull the plugs and they look like it's running rich. What would cause it to run rich at 1/2 to full throttle
  18. Replies
    34
    Views
    4,236

    Ok I'm stumped I just rebuilt the top end on my...

    Ok I'm stumped I just rebuilt the top end on my ski it has low compression on one cylinder. I rebuilt the top end rebuilt the carbs and rave valves. Took it out today and it still is cutting out at...
  19. Replies
    34
    Views
    4,236

    I went threw and changed all the gray line...

    I went threw and changed all the gray line cleaned the selector switch out clean the carbs. Now it idles and runs great tell full throttle then it will cut out. But I just noticed the one of the rave...
  20. Replies
    34
    Views
    4,236

    I have tried new plugs. I will try and cut the...

    I have tried new plugs. I will try and cut the wire back and see if that helps
  21. Replies
    34
    Views
    4,236

    2000 rx cuts out at high rpm's

    I picked up a 2000 Seadoo rx a few months ago and it had a few problems. The first time I took it out the ski wouldn't idle for nothing. But I could get it to go full throttle so I took it home and...
Results 1 to 21 of 21