Search

Type: Posts; User: Mr. GP1800

Page 1 of 8 1 2 3 4

Search: Search took 0.13 seconds.

  1. Sticky: I still use south shore. You can pull up on the...

    I still use south shore. You can pull up on the beach just next to the ramp
  2. I wouldn’t do the intercooler if you don’t plan...

    I wouldn’t do the intercooler if you don’t plan to exceed 8000 rpm. You’ll be all over the limiter. Even without the intercooler you’ll still get to the limiter I’m cooler days unless you’re at...
  3. Replies
    3
    Views
    140

    Do you call them? I’m sure it has a warranty

    Do you call them? I’m sure it has a warranty
  4. Replies
    10
    Views
    346

    The intake manifold on the NA motor is completely...

    The intake manifold on the NA motor is completely different than on the SVHO. I dont think the same applies as far as middle cylinders being leaner. The stock airbox is a lot more restrictive...
  5. Replies
    11
    Views
    442

    That stator is the updated version I would do...

    That stator is the updated version I would do the ohm checks on it. The updated stators rarely fail. There are numerous other things to check for no spark first. Battery must put out 10.6 volts...
  6. Thread: Hood shock

    by Mr. GP1800
    Replies
    6
    Views
    302

    Hopefully your hood shock is working again

    Hopefully your hood shock is working again
  7. I had the ski out earlier this week. I was 1000...

    I had the ski out earlier this week. I was 1000 feet higher in elevation than where I usually ride. It was down 250 rpm from the last ride and probably down 3MPH. I only ran 62.9 as opposed to...
  8. Replies
    17
    Views
    918

    If you are concerned with warranty you want the...

    If you are concerned with warranty you want the 13/20 not the 13/18. The 13/18 will spin 200-300 RPM higher than the 13/20. The Maptuner with the bone stock tune with 8000 limiter or any of the...
  9. If you have nothing connected for a fuel level...

    If you have nothing connected for a fuel level sender it should work just like the oil gauge with nothing connected. Shouldnt trip any warning or low fuel messages. The 33-240 ohm fuel sender is a...
  10. I can program any black potted CDI for a high...

    I can program any black potted CDI for a high start curve.

    No issues there
  11. Replies
    6
    Views
    340

    That’s the speed limiter kicking in.

    That’s the speed limiter kicking in.
  12. Replies
    6
    Views
    284

    Ugly warning decal on seats

    I was at a dealer yesterday and noticed both the yamahas and sea doos had the same butt ugly warning decal embossed into the seats. Is this some new mandate from the USCG or something? Anyone have...
  13. View Post

    Got a chance to run mine. Iím at 580 feet elevation. Air temp was 50-70 depending on where I was. Water temp was 45-48. I ran 7650 rpm and 65 mph with a best of 65.9. Thatís with power filter...
  14. I used the same jetting as the virage tx. It’s...

    I used the same jetting as the virage tx. It’s the same setup you’re trying to build
  15. technically it is

    technically it is
  16. Replies
    8
    Views
    242

    You’ll have to drain the oil. Even after pumping...

    You’ll have to drain the oil. Even after pumping the oil out of the engine when you remove the oil pump you get a good amount of oil that dumps out in the hull
  17. Just put a little bit of 2 stroke oil down the...

    Just put a little bit of 2 stroke oil down the carbs. By the time that burns off you'll have mixed gas flowing. Or you can pull the fuel line off at the carbs and drain it out then it will prime...
  18. Replies
    174
    Views
    80,009

    threads? I bought a 1 1/2 inch pvc pipe cap and...

    threads? I bought a 1 1/2 inch pvc pipe cap and stuck it in the rubber pipe. Fits perfect. Clamp it down and it’s good to go.
  19. Replies
    5
    Views
    167

    1200 cranks have the pork chop shaped webs. ...

    1200 cranks have the pork chop shaped webs. 1050/900 are round.
  20. If you want more sound look at the TJ exhaust...

    If you want more sound look at the TJ exhaust mod. It costs about 2 bucks for a pvc pipe cap and that’s it.

    I have a stage 1+ tune that’s limited at 8000. I run 78 mph consistently. If you...
  21. I don’t know if that would matter much at idle...

    I don’t know if that would matter much at idle but I guess it could be the difference
  22. Replies
    19
    Views
    1,166

    I’ve tried from the TJ exhaust to a rear exit. I...

    I’ve tried from the TJ exhaust to a rear exit. I didn’t think the rear exhaust was any louder at all. Except at idle. The through hull is louder at idle because the exhaust outlet is above the...
  23. Replies
    5
    Views
    167

    It’s a shorter stroke than a 1200 crank.

    It’s a shorter stroke than a 1200 crank.
  24. Replies
    18
    Views
    1,234

    I wonder if the thicker oil made a difference

    I wonder if the thicker oil made a difference
  25. Replies
    3
    Views
    124

    WTB You can get them from McMaster Carr as well.

    You can get them from McMaster Carr as well.
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4