Search

Type: Posts; User: adellicson

Search: Search took 0.00 seconds.

  1. Replies
    31
    Views
    865

    Think I need just a bit more idle. Would it...

    Think I need just a bit more idle. Would it matter where the trim is? Pretty sure the grey cdi wire is connected though. Cdi/stator did not come with directions so that change I did not know about....
  2. Replies
    31
    Views
    865

    casey67, I was able to find the idle knob and...

    casey67, I was able to find the idle knob and adjust. Still isn’t real easy to find just by touch, but at least I know where it is now. Yesterday it stalled on me coming in so I think it needs just a...
  3. Replies
    31
    Views
    865

    Thanks for the info. I see individual adjustments...

    Thanks for the info. I see individual adjustments on center and PTO carb and another one on mag, but what I couldn’t see is the adjustment for the entire linkage. This has aftermarket individual air...
  4. Replies
    31
    Views
    865

    Casey67, fired it up yesterday for 1st time....

    Casey67, fired it up yesterday for 1st time. Other then low idle issue, trying to figure out that one now, it runs really good. Really appreciate all your feedback and help on getting this thing back...
  5. Replies
    31
    Views
    865

    Got it. Makes sense now. Got the used oil pump....

    Got it. Makes sense now. Got the used oil pump. Jackass shipped it in a bubble bag instead of a box. The control lever was spun backwards. I think it screwed up the valve it controls. When I...
  6. Replies
    31
    Views
    865

    Casey67, Quick question, the black wire i spoke...

    Casey67, Quick question, the black wire i spoke about earlier that I no longer need that goes to the neg on battery has 2 spade connectors. 1 connects to the board in the electrical box the other...
  7. Replies
    31
    Views
    865

    There would have been a time when I was more...

    There would have been a time when I was more inclined to pull the motor, but this is honestly my 1st pwc. My brother had a few that I wrenched on, but that's about it. Most of my experience on 2...
  8. Replies
    31
    Views
    865

    Got it. Thanks. When I bought this machine, it...

    Got it. Thanks. When I bought this machine, it did not run at all, but I only paid $300 for it with a galvanized single trailer. It is very clean though, see pic. All I knew was it didn't have...
  9. Replies
    31
    Views
    865

    I noticed both the new(updated) cdi and the...

    I noticed both the new(updated) cdi and the stator black wires have eye loops where before they connected cdi harness to stator harness with the barrel connector. I'm guessing those now go to the...
  10. Replies
    31
    Views
    865

    BTW, finally got into it this weekend. Flywheel...

    BTW, finally got into it this weekend. Flywheel was barely on there. Woodruff key sheared in half. New stator is in, flywheel back on. Never replaced the crank seal as it seemed like more then I...
  11. Replies
    31
    Views
    865

    What was that TSB that removed the little ground...

    What was that TSB that removed the little ground wire running to the battery negative? Mine still has it. Supposed to run it somewhere in the electrical box instead. Can’t seem to find it to know...
  12. Replies
    31
    Views
    865

    Got the seal ordered. Can you explain how the...

    Got the seal ordered. Can you explain how the timing adjustment works? The flywheel is still on there and I know it has to do with the 2 screws with the slots on the front of the flywheel. Do I just...
  13. Replies
    31
    Views
    865

    I see what your saying. I think I’m going to do...

    I see what your saying. I think I’m going to do the seal, put it back together, then crack it open again after a few rides to see if oil comes out of there again.
  14. Replies
    31
    Views
    865

    Casey67, don’t have a problem replacing the crank...

    Casey67, don’t have a problem replacing the crank seal, but I’m not entirely convinced that’s where the oil came from. That would make more sense to me if it was a 4 stroke. Any oil in the crankcase...
  15. Replies
    31
    Views
    865

    I’m confused. Why would I pull the motor out or...

    I’m confused. Why would I pull the motor out or was that a joke? I’m not struggling with anything at this point. Was simply asking about the oil pump drive on the flywheel. I have a service manual...
  16. Replies
    31
    Views
    865

    Hey casey67. Thanks for the info. So I need to...

    Hey casey67. Thanks for the info. So I need to hold the flywheel and throw a wrench on that hex and back it out? How do I check the timing? Cold set it with dual indicator TDC? How would you even do...
  17. Replies
    31
    Views
    865

    1996 SL900, new to forum

    New to forum. Been researching this topic for awhile.

    Picked up a 1996 sl900 in late fall no spark but excellent condition. Has non updated stator and cdi and just ordered it.

    Has tank out...
Results 1 to 17 of 17