Search

Type: Posts; User: xlint89

Page 1 of 8 1 2 3 4

Search: Search took 0.13 seconds.

  1. Thread: PSI Waterbox

    by xlint89
    Replies
    7
    Views
    124

    Check out post #18 Magazine Write Up's/Tech...

    Check out post #18

    Magazine Write Up's/Tech Articles - Page 2 (greenhulk.net)
  2. That's pretty good speed for a 1050..

    That's pretty good speed for a 1050..
  3. Thread: PSI Waterbox

    by xlint89
    Replies
    7
    Views
    124

    Have not seen many PSI water boxes at all. Prob...

    Have not seen many PSI water boxes at all. Prob no different than any other after market one. Maybe a slight increase in acceleration with more increased noise levels.

    You do also have a PSI...
  4. If I'm not mistaken, because the motor mount to...

    If I'm not mistaken, because the motor mount to hull bolt is under the engine mounting plate.

    If you can access them both, go for it.

    There's a ton of info for that engine available. What are...
  5. Replies
    6
    Views
    437

    Ditch the in line fuel filter. Was not used by...

    Ditch the in line fuel filter. Was not used by polaris and is not needed.

    The water seperator has a fuel filter installed into it. Yours is sitting on the bottom of the fuel bowl though. It should...
  6. Have you actually tried installing larger jets? ...

    Have you actually tried installing larger jets?

    I had a problem once that larger jets didn't seem to make a difference. Turned out to be the soft clear fuel lines I was using were collapsing
  7. Replies
    1
    Views
    68

    Welcome to the Hulk. You seem to have...

    Welcome to the Hulk.

    You seem to have something not normal going on there.

    That ski should see 50 MPH with no problem.

    When it acts up, try applying the choke a little bit and see if that...
  8. Replies
    2
    Views
    113

    Best bet is to experiment and see what you get....

    Best bet is to experiment and see what you get. It's really easy to swap them out and do back to back testing.

    I used to beach the ski with the back end on shore and do it right there.

    I found...
  9. Replies
    4
    Views
    230

    WTB - Parts A quick search isn't showing any available. If...

    A quick search isn't showing any available.

    If you're interested in trying something else, I've read the Virage "batwing" ride plate does pretty good. Saw those for pretty cheap if you wanna give...
  10. Replies
    266
    Views
    87,585

    Sticky: This is interesting... Polaris 96 97 1996...

    This is interesting...

    Polaris 96 97 1996 Hurricane 700 Aftermarket ATM Ride Plate Fiber | eBay
  11. Replies
    1
    Views
    76

    Picture please.

    Picture please.
  12. Aluminum colored spark plugs is not good. That...

    Aluminum colored spark plugs is not good. That usually means aluminum from the piston. You'd better look into this pronto.

    Chocolate brown color is what you're looking for.

    Fuel pressure should...
  13. Do you have a picture of the fitting in question?

    Do you have a picture of the fitting in question?
  14. Replies
    4
    Views
    174

    The original Mikuni round single outlet fuel pump...

    The original Mikuni round single outlet fuel pump was rated at 35L per hour.

    Mikuni American Corporation

    I have not read many people having issues with higher output fuel pumps causing...
  15. Replies
    10
    Views
    607

    Leak down sounds like it should be fine then. ...

    Leak down sounds like it should be fine then.

    Restrictor is working? Have you tested fuel pressure to state that? If so, what is your readings at idle and at 3,000 RPM?
  16. Replies
    4
    Views
    155

    I know. I only have 1 impeller like that.

    I know. I only have 1 impeller like that.
  17. Replies
    10
    Views
    607

    Do you have the restrictor in the return hose? ...

    Do you have the restrictor in the return hose?

    Did you ever do a leak down test?
  18. Replies
    4
    Views
    155

    This does happen sometimes. The base of the...

    This does happen sometimes. The base of the impeller may be bottoming out on the stator. Or the trailing edge of the impeller blades may be contacting the vanes of the pump.

    You may need to add a...
  19. Welcome to the Hulk. Have you tested for spark...

    Welcome to the Hulk.

    Have you tested for spark while running? (in line spark tester)

    What do you mean you swapped wires around? I assume you mean the plug wires? Red domestic engine coils have...
  20. Replies
    17
    Views
    616

    All that little gold flake makes me think it was...

    All that little gold flake makes me think it was the connecting rod wearing away. Before SBT came out with rods for the 785, I think shops had to machine down sled rods to work. I wonder if those are...
  21. Replies
    6
    Views
    437

    Your drive shaft is splined and goes into the...

    Your drive shaft is splined and goes into the engine coupler on the engine side. I'm assuming that came unthreaded somehow. That would kind of make sense, but I've never seen one actually loosen up...
  22. Replies
    5
    Views
    443

    That is a small water feed going into the exhaust...

    That is a small water feed going into the exhaust manifold. (It's a 3/8 fitting "T'd" off the 3/4 connection) I do honestly believe that has more to do with the "self draining" part of the system....
  23. Replies
    5
    Views
    443

    If the sizzle is coming from inside the...

    If the sizzle is coming from inside the combustion chamber, it would have to be a head gasket leak, or a cracked cylinder. I still would find it hard to believe the piston or cylinder is so hot that...
  24. Replies
    6
    Views
    437

    Welcome to the Hulk. Where to begin? 1st,...

    Welcome to the Hulk.

    Where to begin?

    1st, these skis doesn't guzzle a lot of gas. A tank full should run for hours of use. Even at WOT. Make sure you don't have a fuel leak. A leak inside the...
  25. Replies
    5
    Views
    443

    Welcome to the Hulk. My first impression when...

    Welcome to the Hulk.

    My first impression when you say you hear sizzling, I assume exhaust. There is a small orifice inside the brass fitting at the top of the exhaust pipe. That inject water into...
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4