Search

Search: Search took 1.00 seconds.

  1. Replies
    4
    Views
    199

    By all means, treat the fuel, then run it long...

    By all means, treat the fuel, then run it long enough to get the treated fuel throughout the system.

    I drain the fuel from mine and run 100 octane avgas through them.
  2. Replies
    4
    Views
    199

    Don’t think it’s much different from what I did...

    Don’t think it’s much different from what I did for my Evinrude 2 stroke motor.
    1. Fill gas tank
    2. Add fuel stabilizer
    3. Wash ski inside/outside and Flush motor with water and/or Saltaway
    4....
  3. Replies
    15
    Views
    635

    voltage over 14.4 is indicative of a bad voltage...

    voltage over 14.4 is indicative of a bad voltage regulator and that can spike the emm and cause all sorts of problems

    connectors are difficult to source, I'd not worry about it too much

    I...
  4. Replies
    15
    Views
    635

    You need a laptop running XP or 98 to run KADIAG....

    You need a laptop running XP or 98 to run KADIAG. You can purchase the cable and s/w from Kawasaki or build you own cable if your technically inclined. I have soft copies of the manuals and s/w. I...
  5. Replies
    15
    Views
    635

    water flow to emm may be restricted. Careful...

    water flow to emm may be restricted. Careful removing the hoses, the connections may be brittle, warm hoses with hair dryer first and take your time
    CPS connection may be hanging on by a thread,...
  6. Replies
    16
    Views
    755

    Disconnect the cables, remove the 4 nuts that...

    Disconnect the cables, remove the 4 nuts that hold the pump on, pull. Be careful, it can break loose suddenly and hurt you.

    Get a service manual.
  7. Replies
    22
    Views
    1,949

    always better to start a new thread for a new...

    always better to start a new thread for a new issue, but I'll indulge you here.

    112 seems a bit low to me. but even across all three jugs is good, very

    I'd get a known good compression gauge...
  8. Replies
    22
    Views
    1,949

    follow-ups are always appreciated by all who come...

    follow-ups are always appreciated by all who come across this stuff in the future needing to know how to solve the problem and it sure keeps us from having to repeat methods and procedures too many...
  9. Replies
    22
    Views
    1,949

    you're wasting your time and effort. Without 13.5...

    you're wasting your time and effort. Without 13.5 v at the battery when the engine is running the problem is most likely the emm. you can check the stator, but problems there typically result in a no...
  10. Replies
    22
    Views
    1,949

    The EMM has the charging circuit in it...

    The EMM has the charging circuit in it (ultimately powered by the stator). There is a common weak point in the charging circuit. I (via Lakeside Tech) can repair your EMM.
  11. Sticky: Just wanted to add to this thread and thank...

    Just wanted to add to this thread and thank Lakeside Tech for professional service and honest business. I am new to the Polaris community and thanks to this forum and Darrin's repair service, the ski...
Results 1 to 11 of 11