Search

Type: Posts; User: rsmartin5

Page 1 of 3 1 2 3

Search: Search took 0.00 seconds.

  1. Replies
    112
    Views
    3,136

    I listed the pins in order, 1-12 is 7.7 ; 2-11 is...

    I listed the pins in order, 1-12 is 7.7 ; 2-11 is 7.8 ; 3-10 is 5.1 ; 4-9 is 5.1 the 5-8 is 5.4. So these readings are or ok? I'm still not getting any fuel to pump or it to turn over. What do you...
  2. Replies
    112
    Views
    3,136

    I got the stator put back in and the readings...

    I got the stator put back in and the readings are;

    7.7
    7.8
    5.1
    5.1
    5.4
    -
    Do you still think the stator is still defective?
  3. Replies
    112
    Views
    3,136

    Well unfortunately I can't blame it on anyone but...

    Well unfortunately I can't blame it on anyone but myself! I took it all apart last night and found that I must not got the wire harness tight / secure in the assembly and the flywheel teeth must have...
  4. Replies
    112
    Views
    3,136

    Is it common to get a faulty stator?

    Is it common to get a faulty stator?
  5. Replies
    112
    Views
    3,136

    So checking the AC again we are not getting...

    So checking the AC again we are not getting anything out of the 2-11 pins OHMs or AC. The 1-12 pins were 8.0 and the rest were 5.4
  6. Replies
    112
    Views
    3,136

    I need to take that back, I haven't retested the...

    I need to take that back, I haven't retested the low voltage since I put the new stator in.
  7. Replies
    112
    Views
    3,136

    The AC was measured at the red / white wire, red...

    The AC was measured at the red / white wire, red to wire and grounded at a bolt on the head. The low AC reading hasn't been fixed
  8. Replies
    112
    Views
    3,136

    The ACV readings of 26.6 and DCV readings of 13.4...

    The ACV readings of 26.6 and DCV readings of 13.4 at the red/white wires while cranking.
  9. Replies
    112
    Views
    3,136

    After charging the battery all afternoon the best...

    After charging the battery all afternoon the best reading I got was 13.8dc out of it tonight. What do you think I should try now.
  10. Replies
    112
    Views
    3,136

    I am calling the pin that I am sliding in the...

    I am calling the pin that I am sliding in the harness the jumper. I will retest tonight. I think my battery is good, but could a run down battery cause the reading to be low?
  11. Replies
    112
    Views
    3,136

    Is there only one white/red wire on the harness?...

    Is there only one white/red wire on the harness? I tested 2 wires
  12. Replies
    112
    Views
    3,136

    Of the harness, I am testing each wire. Positive...

    Of the harness, I am testing each wire. Positive to the jumper in the harness and negative to the battery. Is that right or am I doing it incorrectly?
  13. Replies
    112
    Views
    3,136

    11.8 and 12.5 are the readings

    11.8 and 12.5 are the readings
  14. Replies
    112
    Views
    3,136

    New readings 11.8 one side and 12.4 on the 5 on...

    New readings 11.8 one side and 12.4 on the 5 on the other.
  15. Replies
    112
    Views
    3,136

    I'm not getting any readings from the white/red...

    I'm not getting any readings from the white/red wire on the 8 pin connector on the DC side. Connecting one end to the negative on the battery , other in the pin.. The red/blue wires will read 12.7...
  16. Replies
    112
    Views
    3,136

    When you say the white/red wire, are you talking...

    When you say the white/red wire, are you talking the 2/11 plugs from the stator?
  17. Replies
    112
    Views
    3,136

    It's been replaced. It took a while to get it and...

    It's been replaced. It took a while to get it and I finally got it put in.
  18. Replies
    112
    Views
    3,136

    I should say with the TPS plug in.

    I should say with the TPS plug in.
  19. Replies
    112
    Views
    3,136

    What should I check for, I tried to start it and...

    What should I check for, I tried to start it and I'm not getting any spark and the fuel pump isn't working without the TPS unplugged again.
  20. Replies
    112
    Views
    3,136

    I finally got the stator back in and was able to...

    I finally got the stator back in and was able to test it while cranking and this is what its reading. Meter at 200A/C

    1&12 - 7.5
    2&11 - 2.4
    3&10 4&9 5&8 all read 5.0.

    Does this seam right?
  21. Replies
    112
    Views
    3,136

    I am not completely sure where the spring is...

    I am not completely sure where the spring is supposed go. Are you talking where the end of the starter shaft goes in on the cover?
  22. Replies
    112
    Views
    3,136

    I am looking for a part number for a starter...

    I am looking for a part number for a starter clutch. The one I have is stuck in the engaged position.
  23. Replies
    112
    Views
    3,136

    The magnet on the flywheel doesn't seem to be...

    The magnet on the flywheel doesn't seem to be much, can I get by with just replacing the stator?
  24. Replies
    112
    Views
    3,136

    Is there a way to test the shaft bearing? From...

    Is there a way to test the shaft bearing? From what I can see and feel it seems tight.
  25. Replies
    112
    Views
    3,136

    465939 I did more looking and found this...

    465939

    I did more looking and found this damage. There was a broken of screw that holds the stator on. Is there a chance the screw could have caused this damage?
Results 1 to 25 of 52
Page 1 of 3 1 2 3