Search

Type: Posts; User: John F.

Page 1 of 8 1 2 3 4

Search: Search took 3.26 seconds.

  1. Replies
    2
    Views
    180

    I have a set on and they are pretty aggressive...

    I have a set on and they are pretty aggressive even in the up position.
    When I 1st rode with them on I made a 50+ crouched sweeping turn on the creek.
    The sponsons grabbed hard and almost through...
  2. Replies
    22
    Views
    1,458

    It could very well be the Riva plate. Let us...

    It could very well be the Riva plate.
    Let us know your results after testing.
  3. Replies
    22
    Views
    1,458

    I believe it depends on the ski. Some do not...

    I believe it depends on the ski. Some do not bounce, but most of the ones I hear about do.
    The one's that do not bounce with the Riva plate are typically a few mph faster than the skis that bounce....
  4. Replies
    22
    Views
    1,458

    My 2019 FX with the Riva rie plate also had the...

    My 2019 FX with the Riva rie plate also had the bounce.
    I switched to a Protec extended nozzle with a 91mm exit and it took the bounce out but that particular nozzle was discontinued.
    I ordered a...
  5. Replies
    12
    Views
    1,330

    The supercharger bearing is also different from...

    The supercharger bearing is also different from my older FZR.
    I can't tell if it is 1 or 3 piece bearing.
  6. Deka ETX16L

    Deka ETX16L
  7. I had a JL audio setup on my last FX. The pic...

    I had a JL audio setup on my last FX.
    The pic that I shared was just showing it has been done on the GP1800.

    This link below is my current setup....
  8. The stand alone bluetooth speakers loudness are...

    The stand alone bluetooth speakers loudness are good if docked or idling only.
    For around $900 you can get a Marine JL Audio setup that works on the GP1800.
    MBT -CRXv2 Bluetooth Controller $98...
  9. I replaced my Titan torsion axle and it just...

    I replaced my Titan torsion axle and it just unbolts.
  10. Replies
    24
    Views
    1,353

    I emailed Jesus earlier this day to send me a...

    I emailed Jesus earlier this day to send me a tune for the stage 3 9300 17lb wheel.
    If Jesus is still a work I should be ready to ride it by this weekend.
  11. Replies
    24
    Views
    1,353

    I have had no reliability issues with my 19...

    I have had no reliability issues with my 19 FXSVHO and have around 30hrs on it.
    The only issues I see if tuned, an after market or modded ride plate is a must and I also had a bounce issue with the...
  12. Replies
    10
    Views
    611

    Does it have the smaller fuel pump? If so there...

    Does it have the smaller fuel pump?
    If so there are 2.
    I overlooked the second one also but found it in the extender piece for the shorter fuel pump.
  13. Replies
    25
    Views
    2,140

    Dan, the fuel tank vent line goes to the water...

    Dan, the fuel tank vent line goes to the water separator then exits out over the right side of the upper hull(under the cowling) which would drain into the right foot well.
  14. Replies
    10
    Views
    611

    If the 2018 GP1800 has the smaller fuel pump like...

    If the 2018 GP1800 has the smaller fuel pump like the 2019's there are 2 black rubber spacers, one is larger in diameter if I remember correctly.
    Make sure you have the larger one on.
  15. Replies
    34
    Views
    1,561

    Dan, in the past I used the Bosh 4.2 O2 sensors...

    Dan, in the past I used the Bosh 4.2 O2 sensors in my skis running them for several years without replacement.
    But now on my 19 FXSVHO and my 09 FZR I use the Bosh 4.9 O2 sensors and they don't...
  16. Thread: Awlgrip paint

    by John F.
    Replies
    1
    Views
    262

    If spraying with a HVLP I always use an...

    If spraying with a HVLP I always use an accelerator to speed up cure time and serviceability.
    When spraying your hull you can also spray a sample on a 4x4" gloss ceramic bath tile and check the...
  17. Replies
    56
    Views
    5,664

    With the 3 heads I have had crack, the skis were...

    With the 3 heads I have had crack, the skis were flushed with salt away after every ride so I doubt there was very much corrosion involved.
    I also let the motor get up to 150F if I have a gauge or...
  18. Replies
    56
    Views
    5,664

    I ride in the same area as you and have had 3...

    I ride in the same area as you and have had 3 heads crack and my friend I ride with has had at least 1 head crack as well.
    We both do proper warm up and cool down of the skis and monitor engine...
  19. Replies
    20
    Views
    1,246

    I once had a Riva FPR guage that was bad and read...

    I once had a Riva FPR guage that was bad and read about 20 psi too low.
    Not sure if that is your problem since stock fuel pump is idling ok.
  20. Replies
    30
    Views
    1,574

    The TX goes to the Maptuner screen. If you still...

    The TX goes to the Maptuner screen.
    If you still can't get it to work work submit a support ticket at this address.

    https://plxdevices.freshdesk.com/support/tickets/new
  21. Replies
    30
    Views
    1,574

    Read Step 2. As I stated in my last post. ...

    Read Step 2.
    As I stated in my last post.
    Disconnect the RX plug on the last PLX and put back in the jumper to see if your maptuner can read the O2 sensor data.
  22. Replies
    30
    Views
    1,574

    Do you have the jumpers installed on all of the...

    Do you have the jumpers installed on all of the PLX's?

    1st try unplugging the RX on the last PLX by the battery and see if the Maptuner reads the single PLX O2 sensor.
    Also make sure the jumper...
  23. Replies
    2
    Views
    355

    Touch the red triangle at it will display the...

    Touch the red triangle at it will display the fault on the dash screen.
  24. Some people have had good results by cutting the...

    Some people have had good results by cutting the 1" rear lip off of the back of the ski.
    The upper deck lip grabs the water when on glass and causes the ski to rock side to side.
  25. Replies
    104
    Views
    6,476

    The fuel pressure stays steady until around...

    The fuel pressure stays steady until around 4200rpms and then progressively gets worse at higher rpm's.
    Nil's confirmed there is an issue but was not sure what was the exact cause.
Results 1 to 25 of 199
Page 1 of 8 1 2 3 4