Search

Type: Posts; User: TimeBandit

Search: Search took 0.00 seconds.

  1. Replies
    60
    Views
    4,434

    Yeah, in that 1st pic, the rubber should not be...

    Yeah, in that 1st pic, the rubber should not be separating like that - its done for sure. You can even see on the housing where the rubber's lip sits recessed that the housing oxidation/swelling...
  2. Replies
    60
    Views
    4,434

    One thing that works well for me. . . once the...

    One thing that works well for me. . .
    once the engine is suspended by the hoist, connect a ratchet strap from the engine to the ski's bow-eye to help pull & hold the engine as far forward as...
  3. Replies
    60
    Views
    4,434

    superair - thanks for the correction on the press...

    superair - thanks for the correction on the press direction - it been a while since I did mine.
    I do remember a need to remove it however, and I want to say I needed to because otherwise it was near...
  4. Replies
    60
    Views
    4,434

    Coupler must be spun off the mid-shaft, then the...

    Coupler must be spun off the mid-shaft, then the threaded side of the mid-shaft gets pushed into and out the aft side of the housing.
    Correction : mid-shaft gets pressed out of the fwd direction.
    A...
  5. Replies
    60
    Views
    4,434

    Sounds like you are halfway there - tool-wise. ...

    Sounds like you are halfway there - tool-wise.
    For those "special" tools, the manual lists two for this job : 1) a coupler-wrench and 2) a mid-shaft holding tool.
    All they do is help you spin the...
  6. Replies
    60
    Views
    4,434

    "If it is said that a picture is worth a thousand...

    "If it is said that a picture is worth a thousand words... your video is worth a million." - thanks for posting that.

    First, I've not seen the whole IB assembly sold fully assembled by a parts...
Results 1 to 6 of 6